INSIDE THIS INSTRUCTION MANUAL |
|
Important Safety Instructions / Features | 2 |
Product Features / Precautions | 3 |
Amplifier and Mixer Descriptions | 4 |
Contact Information | 8 |
IMPORTANT SAFETY INFORMATION 1) Read these instructions.
2) Follow all instructions
3) Keep these instructions
4) Heed all warnings
5) Do not use the
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Use in accordance with manufacturer’s instructions.
| HEED ALL WARNINGS | |
CAUTION | WARNING: To reduce the risk or fire or elec- | |
trical shock do not expose this equipment to | ||
RISK OF ELECTRIC SHOCK | ||
DO NOT OPEN | rain or moisture. | |
|
CAUTION: Connect the power cable only after you have made absolutely sure the local mains voltage matches the voltage specified on the device. If you connect to the wrong voltage, you may destroy the electronic components of the
Stereo Power Amplifier features
8) Do not use near heat sources such as radiators, stoves or other devices that may produce heat.
9) Do not defeat the safety purpose of the polarization or
•Output stage with discrete devices, not integrated IC amps
•Output power of 2 x 100w RMS with significant headroom for peaks
•Comprehensive amplifier and speaker protection circuitry to guard against short circuits, DC offsets,
•
•Equalization customized to enhance and optimize speaker system performance
•Output for stereo headphones on rear panel
•Very efficient cooling, utilizing a large heatsink and two direct flow fans
•Power supply with
safety. If the provided plug does not fit your outlet, consult an electrician for replacement
5-Channel Mixer features
of the obsolete outlet.
10) Protect the power cord from being walked on or pinched, particularly at the plug and at the point where it exits the
11) Only use attachments / accessories recommended by
12) Use caution when transporting the system to avoid injury from
13) Unplug the
14) Refer all servicing to qualified personnel. Servicing is required when the
•Four channels with both balanced XLR mic inputs and unbalanced 1/4” jack line level inputs
n 15Vdc phantom power on balanced XLR inputs for condenser microphones
n Independant PAN, TONE and EFFECT LEVEL controls on each channel
•One stereo channel for variety of sources:
n1/4”
n3.5mm Stereo Jack for MP3 / CD players n Dedicated mono 1/4” Jack INSTRUMENT input with frequency response contoured
for acoustical instruments
•Low distortion, low noise circuitry
•PLAYBACK input/output RCA connectors with LEVEL control
•PATCH section to connect optional external processors, external effects and foot switch
•
•XLR output for external subwoofer.
•Sub switch not only engages low
frequency output but also removes deep bass from satellites thus increasing dynamic range and lowering overall system distortion
|
| |
Loudspeakers | ||
|
operate normally, or has been dropped.
15) The
•Dual 6.5” drivers optimized for D’Appolito (mirrored woofers) configuration
•1” exit phenolic tweeter on exponential horn ideally matches dual 6.5” speakers
Complete system
Dimensions: | 20” (W) x 32“ (H) x 15” (D) |
Weight: | 80 (lbs) |
• Eight
nLevel control to mix processed signal with main signal
nINPUT/MASTER switch to route effects to either Master section or to individual channels
•Sophisticated mixer topology allows the combination of external effect devices to be used in combination with internal DSP
2
Note: Specifications are subject to change without notice