Eton ARCFR800R user manual If you want to receive all alerts, To set single or multiple codes

8

SETTING ALERT MODE (SIREN or VOICE)

Turn off the radio and press the MENU button. SETUP TIME appears in the display. Press the button twice. ALERT appears in the upper part of the

display, with SIREN or VOICE to its right. Press the button and SIREN

or VOICE flashes. Press the buttons to select the one that you wish to hear when an ALERT is activated. Press MENU twice to exit and save the setting.

While the alert SIREN is activated, you can press the ON/OFF ALERT button at the top of the radio to turn it on or off.

SETTING S.A.M.E.

Codes in the US, CLC Codes in Canada

•S.A.M.E. = Specific Area Message Encoding

•CLC = Canadian Location Codes

A six-digit code instructs the radio only to receive an ALERT when the code is programmed in. There are far too many S.A.M.E and CLC codes to include them all in this manual. We therefore provide the following to assist you in looking up the code for your area.

Look up a United States county code at the following web site: http://www.nws.noaa.gov/nwr/indexnw.htm#sametable

Look up a Canadian CLC code at: http://www.msc-smc.ec.gc.ca/msb/weatheradio/transmitter/index_e.cfm

Your radio can be set for one (SINGL) to 23 (MULTI) codes, or can be set to receive ALL coded information sent from any transmitter, if you’re within range. When you set codes, it will only pick up alerts when you’re in that county or within reception distance of the signal. ALL, MULTI

or SINGLE COUNTY will appear in the lower left side of the display, depending on how you have set it.

USER MANUAL WEATHERTRACKERFR800

If you want to receive all alerts:

COUN TY	ALERT SIREN	COUN TY	ALERT SIREN	COUN TY	ALERT SIREN
SINGLE		SINGLE		SINGLE

1 2 3

Turn POWER off		Press MENU		Press	and
				choose COUNTY
COUN TY ALERT SIREN		COUN TY ALERT SIREN		COUN TY	ALERT SIREN
SINGLE		SINGLE		SINGLE
4		5		6
Press	and the	Press	until	Press MENU twice to
display will flash		COUNTY - ALL		exit and save the setting

9

To set single or multiple codes:

Select SINGLE below if you only want to enter a code for a single area. Enter MULTI if you wish to enter multiple codes for different areas. Remember, you must be in that area to receive the ALERT for the area.

1.Turn the radio off.

2.Press the MENU button to enter the setting menu.

3.Press the buttons to select COUNTY at the top of the display with SINGLE, MULTI or ALL to the right of it.

4.Press the button to make the wording to the right of COUNTY flash.

5.Press the buttons to select SINGLE or MULTI.

Continues on next page...