electrocution or electric shock hazard

The use of the Power Port to run an extension cord into the tent could result in electrocution or electric shock, or fire or explosion hazards, which could cause death, serious injury, or permanent disability. For these reasons, when using the Power Port:

DO follow all warnings, instructions, and safety precautions from the manufacturer of the extension cord.

DO connect extension cord only to a 120 Volt GFCI protected outlet with proper ground. If GFCI outlet is not available, use an extension cord with GFCI protection built in.

DO use only extension cords that are marked for OUTDOOR USE. DO make sure the part of the extension cord that is outside the

tent is lower than the Power Port so that rain will not follow the cord into the tent.

DO store extension separately from tent.

DO NOT allow extension cord or any electrical device to come into contact with water or condensation inside the tent.

DO NOT use extension cord if it is worn or damaged.

DO KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84.The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the

flame-resistant properties ineffective.

DO NOT operate any device which burns fuel inside your tent. Combustion consumes oxygen and can produce dangerous levels of carbon monoxide, which could lead to serious injury or death.

Your failure to follow these warnings could cause death, serious injury or permanent disability to you or others.

SEAM SEALING:

We recommend use of a sealer such as Kenyon Seam Sealer 3 or McNett Outdoor SeamGrip®.

Work in a fully ventilated area.

Set the tent up or lay the tent out flat. Taut seams allow for even application and penetration of the sealer.

Decide which seams need to be sealed. For example, seams that will be exposed to rain, runoff, or ground level water are a must for sealing, while seams on uncoated nylon or mesh panels don’t need treatment. There is no need to seal the seams in the roof or the factory taped seams. We recommend sealing both floor and fly seams and reinforcements.

Apply sealant to the inside and outside of all exposed seams. Several thin layers will work better than one thick layer. Read and follow manufacture’s instructions.

STAKING:

All tents need to be staked down to keep them from blowing away. Securing the tent by placing heavy objects inside is just not adequate.

Once the tent body is erected, stake it out before the fly is put on. This enables you to square the tent up to ensure that the fly goes on properly and that the seams align with the frame. Pull the base of the tent taut between each web

stake out loop or ring & pin. Make sure that all corners are square. It is important that you don’t stake the tent out too tightly. You will know it’s too tight, if the door zippers can not be easily operated. Drive stakes through the web loops, or with ring & pin, drive the stake just outside the ring so that the “J” hook catches it. Tie a piece of cord or web into a loop through the ring to be used as a large stake loop if needed.

With the tent properly staked, drape the fly over the frame, attach its tent connection points and stake down any pull outs.

Do not attempt to remove the stakes by pulling on the tent becket loop, as this could cause the fabric to tear. The best way is to pry on the stake itself.

Staking in special conditions:

Sand. Use long, broad stakes with plenty of surface area in loose soil.

Hard, Rocky, or Frozen Soil. Steel stakes work best. Store steel stakes separately. Their sharp edges can cut fabric and leave rust stains, which might damage your tent.

Snow. Use “dead man” anchors. Tie tent to buried objects (branches, tent bags, or stuff sacks filled with snow; or tie tents to snow shoes, skis, or ski

poles, which are stuck in the snow.

GUY LINES:

Do not depend upon staking alone to keep your tent secure during high winds. The Copper Canyons have built-in loops and guy lines at optimal guy out locations. It’s important to put in the extra time guying out your tent. Correctly done, it can save your tent during exceptional weather.

Make sure that the top fly is securely attached to the tent frame. Hook and loop fasteners are sewn to the underside of the fly for this purpose.

There are guyout points with guylines preattached at primary locations. Stake those guylines 6’ from the edge of the tent. The optimal angle from the ground to the guyline is 45˚. See fig a.

In high winds guylines should be attached to the secondary web loops on each corner, and center on the 1312/1512, and halfway down the tan mid-poles on the 1312 and 1512. See fig b. Attach parachute cord and stake per the previous notations. This prevents all movement, except toward the anchor. The guy lines will work together through opposition. See illustrations below:

fig a

fig b

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CONDENSATION & VENTING:

Through perspiration and breathing, an adult gives off about a pint of water overnight. If it cannot escape, the water vapor condenses to liquid. Most often, water found in the tent is a result of this condensation rather than from the tent leaking. Condensation often forms where the sleeping bag touches the side of the tent, under the sleeping pad, or on coated surfaces such as the door flaps. A tent’s double wall construction allows the vapor to escape through the roof to the outside, keeping the inside of the tent dry.

Leave the windows partially open at night to provide cross ventilation and further reduce condensation. Cross ventilation becomes more important in very humid or extremely cold conditions when the permeable roof is less effective. The features that enhance ventilation are windows, short-sheeted flys (bottom venting), roof vents, and High/Low venting doors. These are

specific to each tent model.

Given the importance of proper ventilation, We use High/Low venting in most of our tents. This allows cooler air in through the low vents and warmer, moist air up and out through the high vents. High/Low venting is accomplished within the inner tent via roof vents, doors and windows. It is important to vent the vestibule. Unvented, it can inhibit airflow into the tent. Eureka! tent vestibules profit from the ability to “short sheet” by means of zippers & toggles and staked vestibule pull outs create a bellowing effect.

Most of our tents are equipped with a High/Low venting door. This design allows increased airflow into the tent from the bottom. Open the low vent/window to admit cool air, allowing the warmer air out through the high roof vents. When rain and wind prevent the low vent from being opened, the high door vent can still be used. Fly overhangs or vestibules protect it.

ULTRAVIOLET LIGHT:

Ultraviolet light damage to tent fabric is caused by excessive exposure to sunlight. While our fabrics are UV resistant, any synthetic fabric is susceptible to UV degradation. UV damage will cause nylon and polyester to become brittle and tear easily. We recommend that you use the rain fly even on clear days. It acts as a sunscreen to the tent. A rain fly is both easier and less expensive to replace if damaged. UV damage can be minimized by erecting tents on shaded sites with low exposure to direct sunlight.

Never let tent poles- snap together as this can damage the pole end.

Do not drop tent or pole bags on their ends and do not bounce a tent bag on its end to get the tent out. These actions may cut the shock cord and damage the pole ends.

The aluminum frame may bend slightly and take a “set” through usage; this normally does not affect the performance of the frame.GENERAL POLE CARE:

GENERAL TENT CARE:

Sweep the tent floor daily to prevent damage from stones.

Try not to wear shoes inside your tent.

Use a ground cloth whenever possible.

Do not keep food inside a tent. Hungry critters will chew through tent fabric in search of food.

STORAGE:

Make sure the tent is completely dry, then store loosely rolled, in a dry, cool place. To prevent dust from collecting on the tent, cover it with a cloth. This allows the nylon/polyester fabric to breathe.

Ideally, the tent poles should be stored in their fully assembled state. This reduces the tension on the shock cord, prolonging its life.

The tent bag should be used only as a carry sack and not for storage.

COLOR TRANSFER:

Do to the nature of tent fabrics, color can transfer from darker to lighter fabrics when the two fabrics are in contact over time when wet, damp or exposed to the combination of moisture and high heat. This does not effect the tent’s performance. To prevent / minimize color transfer, always make sure your tent

is completely dry prior to packing and storage.

CLEANING:

Clean the tent by setting it up and wiping it down with a mild soap (liquid hand soap) and lukewarm water solution. Rinse thoroughly and dry completely. Never use detergent, washing machines or dryers because they can damage the tent’s protective coating and seams. After cleaning, be sure the tent is completely dry, especially the heavier, double-stitched areas such as the seams, before storing or mold / mildew are likely to grow.

Clean the tent poles with a cloth and lubricate them with silicone spray. This is especially necessary after ocean side camping to remove salt spray so the poles don’t corrode or stay gritty.

Clean the zippers with a quick dip in water and then dry them off. This is

especially important if you’ve been camping in a location with sand/dirt. If you don’t clean the zippers, the sliders will wear out and eventually the teeth will become inoperable.

ALTERATIONS OR MODIFICATIONS:

DO NOT misuse, modify or alter this product in any way from its condition at the time of sale. Alteration, modification or any use of this product contrary to the accompanying written instructions shall void the warranty. Moreover, any misuse, alteration or modification of the product shall absolve Johnson Outdoors Gear LLC. of any liability for property damages or injuries sustained as a result of such misuse, modification or alteration.

LIMITED WARRANTY:

What Is Covered: Johnson Outdoors Gear LLC warrants to the original purchaser that its Copper Canyon tents are free from defects in material and workmanship, for the life of the product, except as qualified below. The life of the product is determined from the date of purchase until such time as the product is no longer serviceable due to normal wear and tear.

What Is Not Covered: Johnson Outdoors Gear LLC shall not be responsible for the natural breakdown of materials that occurs inevitably with extended use (e.g., Ultra Violet (UV) light damage on tents, exhausted zippers), or defects caused by accident, abuse, alteration, animal attack, storm damage, misuse or improper care.

THERE ARE NO OTHER EXPRESS WARRANTIES BEYOND THE TERMS OF THIS LIMITED WARRANTY. IN NO EVENT SHALL JOHNSON OUTDOORS GEAR LLC BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

What Johnson Outdoors Gear LLC Will Do: If after inspection we find that a product failed due to a manufacturing or material defect, we will repair or replace the product, at our option, without charge.

How to Obtain Warranty Service: Return the product, freight prepaid, to the Dealer from whom it was purchased; or, contact our Customer Satisfaction Department for return authorization: toll free 1-800-572-8822. Collect shipments or shipments without return authorization cannot be accepted. The product registration card packaged with our product need not be returned for the warranty to be effective and for you to receive warranty service.

Repairs: If your Johnson Outdoors Gear LLC product needs service or repair due to normal wear and tear, animal attack, accident or some other reason that is not covered under the warranty we will provide the necessary service for a reasonable charge, plus shipping and handling. We require that products accepted for any repair be properly cleaned according to our recommended care instructions. Please send your product or component that requires repair (e.g., tent fly), postage prepaid, along with a description of what needs attention. For service and repairs, please contact our Customer Satisfaction Department: toll free 1-800-572-8822

How State Law Relates To This Warranty: This warranty gives you specific legal rights, and you may have other rights that vary from state to state.

JOHNSON OUTDOORS GEAR LLC

We support the “Leave No Trace” Seven Principles

1. PLAN AHEAD AND PREPARE

 

2. TRAVEL & CAMP ON DURABLE SURFACES

 

3. DISPOSE OF WASTE PROPERLY

 

4. LEAVE WHAT YOU FIND

 

5. MINIMIZE CAMPFIRE IMPACTS

 

6. RESPECT WILDLIFE

 

7. BE COURTEOUS OF OTHER VISITORS

REV D. FEB-09

Page 2
Image 2
Eureka! Tents Copper Canyon 1610 Seam Sealing, Staking, GUY Lines, Condensation & Venting, Ultraviolet Light, Storage

Copper Canyon 1610 specifications

When it comes to camping, having the right tent can make all the difference in creating a comfortable and enjoyable outdoor experience. The Eureka! Tents Copper Canyon 1610 is a perfect blend of space, durability, and practicality, tailored for families or groups of campers seeking a cozy shelter while retaining the spirit of adventure.

One of the standout features of the Copper Canyon 1610 is its generous size. With a 10-person capacity, this tent provides ample room for everyone, making it an ideal choice for family outings or camping trips with friends. The tent boasts a spacious footprint, allowing campers to utilize the area efficiently while still having room to move around comfortably. The high peak height further enhances the livability of the space, enabling users to walk comfortably within the tent without the hassle of crouching.

The design of the Copper Canyon is anchored in Eureka!’s commitment to quality and innovation. The tent is constructed using durable materials that can withstand various weather conditions. A robust polyester fabric provides excellent water resistance, while the tent’s floor features a tough polyethylene material to protect against ground moisture. Additionally, the tent includes welded seams to prevent leaks, ensuring that campers stay dry during unexpected rain showers.

The Copper Canyon 1610 also incorporates a unique cabin-style design that provides vertical walls, maximizing internal space. This thoughtful architecture enables campers to set up sleeping arrangements or move around freely without feeling cramped. The tent features multiple windows, allowing for superior ventilation and visibility, ensuring that the interior remains fresh and airy.

One of the notable technologies that Eureka! uses in the Copper Canyon is its Easy Setup System, which streamlines the process of pitching the tent. This feature is especially appreciated by campers who prefer a hassle-free setup after a long day on the trail. The color-coded poles make it simple to assemble, while the tent’s design allows for rapid disassembly when it's time to head home.

For enhanced organization, the tent includes multiple internal pockets for storing smaller items, like phone chargers or headlamps, keeping the interior tidy. Furthermore, the tent's design accommodates optional vestibules for added storage space, allowing campers to keep their gear separate from the main living area.

In summary, the Eureka! Tents Copper Canyon 1610 is an exceptional choice for those seeking a spacious, durable, and user-friendly camping tent. With thoughtful design features, advanced materials, and a convenient setup process, it delivers a comfortable and enjoyable camping experience that will make it a favorite for years to come. Whether you're embarking on a family camping trip or enjoying a weekend with friends, the Copper Canyon 1610 is ready to stand up to the adventure.