Eureka! Tents Equinox 6 manual Assembly Instructions for the Equinox, Your Tent is Ready for Use

Assembly Instructions for the Equinox 6:

This is a large tent and we recommend that you have help.

With first time set-up or with windy conditions, you will need help.

Component List:
1	Tent Body	6	Poles	1	Fly	2 Brim Rods
1	Tent Bag	1	Pole Bag	1	Stake Bag w/ Stakes

• Unpack the tent bag, pole bag and separate all of the components. Unroll and unfold the fabric with the Eureka! label up. Locate the hub fitting attached to the center of the roof. See fig.1.

Important: Align the hub arms to match the layout of the fabric.

fig.1

• Assemble all of the shockcorded poles. Check and make sure that each section is fully seated into the next. Slide a swedged pole section labeled "TOP " into a hub arm.

See fig.2.

•Repeat with a second pole onto the opposite hub arm to form

and arch. Attach the pole clips as you work.

See fig. 4 & 5.

fig.4

fig.5

•Lift the arch and continue attaching all remaining poles and clips until you have a free standing

structure. See fig.6.

fig.6

•Drape the fly over the tent with "Eureka!" above the door. Fit the brim rods into the grommets on the tent wall and into the web pockets on the

underside of the fly. See fig.8.

fig.8

fig.9

• Reach under the fly and locate the Velcro® tabs. Wrap these around the tent poles to secure the fly to the frame. Attach the shockcorded S-hooks from the fly to the staked rings. See fig.9.

Your Tent is Ready for Use!

NOTE: In the event of strong wind, we recommend that the storm rings on the fly be guyed out. See fig.10.

fig.10.

•Make sure the hub and fabric are still aligned. Then, insert the proper corner ring & pin into the bottom pole section.

See fig.3.

fig.2

fig.3

fig.7

• Move the tent to the desired location and stake down all corner rings. See fig.7.

REV. E 11.07