Eureka 200 Series How To Assemble, Connect Handle, Attach Floor Nozzle, Cord Retainer, Wrap Cord

Models: 200 Series

1 12

Page 5

NOTE: Assemble completely before using. Remove and identify parts to be assembled.

Floor Nozzle

1.Hold handle tube with flat side up, handgrip curved toward the back.

2.Push handle into top of housing until the button snaps into place.

3.Place floor nozzle into lower end of cleaner

4.Give a slight twist to secure.

5.Align arrows.

6.Secure electrical cord into cord retainer on handle. Cord stays in retainer unless handle is taken off.

7.Wrap cord loosely around upper and lower cord hooks.

8.Secure plug to cord to prevent unwrapping.

9.Cleaner may hang by handle or store on a shelf.

If needed, remove the handle to conserve storage space. Remove cord from cord retainer to remove handle.

Image 5

Contents

Owner’s Guide 200 Series Vacuum CleanerIndex Household TypeSAVE THESE INSTRUCTIONS IMPORTANT SAFEGUARDSREAD ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER AVERTISSEMENT CONSEILS DE SÉCURITÉCONSERVEZ CES INSTRUCTIONS LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER VOTRE ASPIRATEURGENERAL INFORMATION Service InformationRating Plate USA Mexico CanadaStore Cleaner HOW TO ASSEMBLECleaner Floor Nozzle Connect HandleVariable Speed with Control Switch HOW TO USEStair Cleaning Handle PowerRemove motor filter from dust container and empty contents HOW TO MAINTAINEmpty Dust Container Push latch down. Pull out dust containerReplacement Filters Clean FiltersCleaner Care Clean final filter as needed$3.75 Genuine Eureka PartsTOTAL TOTAL ENCLOSEDPage What This Warranty Does Not Cover What This Warranty CoversExtended Warranty for Upright Cleaner Warranty Registration Obtaining Warranty ServiceQuestions & Answers about Genuine Eureka Products Further Limitations and ExclusionsGENUINE For Genuine Eureka Value, Accept No Imitations