Eureka 7700, 7900 warranty Dirt Alert Feature On some models, ESP Extra Suction Power

Dirt Alert Feature (On some models)

The dirt alert sensor uses infra-red technology to indicate whether or not floors are clean. When debris breaks the light beam, the red light comes on indicating additional cleaning is needed in this area. If there is no break in the light beam, the floor is clean and no red light will come on.

When using your new vacuum you may be cleaning deep down hidden dirt missed by your old vacuum causing the light to stay red longer. With frequent cleaning, after the first few times you use your new Eureka vacuum, the red light should go on less.

NOTE: The dirt alert feature is not intended to be used for above the floor cleaning with attachments.

If the red light stays on continuously, you can quickly check to see if the dirt sensor is working properly. Tip the vacuum backwards on rear wheels, lifting the brush roll off the carpet a couple of inches, after a few seconds the light should turn off. If it does not, then turn the vacuum off, unplug it and continue on to the next section of checking the dirt sensor for light beam interruption.

HINT: IF THE RED LIGHT WILL NOT GO OFF, turn off the vacuum, unplug and check for debris in the dirt channel which may be blocking the sensor beam.

Or, the dirt sensor may be dirty. See the next section to clean the emitter/sensor lenses.

DIRT Y

The red light indicates dirt, dust, etc. is still being removed from the area being cleaned.

How to Check the Dirt Alert Sensor for Interruption in Light Beam

There is an emitter and sensor lens located in each side of the dirt channel in the bottom of the base unit. In order to operate efficiently, the lens will need to be wiped off with a damp cloth followed by a dry cloth periodically.

NOTE: Turn off the switch and unplug the electrical cord before removing base plate on the base unit.

1.Turn the cleaner over. Pull up firmly to remove base plate.

2.Wipe off emitter and sensor lenses with a damp cloth followed by a dry cloth. They are located at the bottom of the side walls in the dirt channel. Check the brush roll for any threads, hairs, etc. and remove.

3.Slant front of base plate to catch tabs into cleaner slots. Push down above each hook to snap base plate back into place.

ESP - Extra Suction Power

Dirt

BaseChannel

Plate

Emitter/

Sensor

Lens

Tabs

Slots

(On some models)

The ESP feature provides two settings for cleaning power. Position one setting should be used for normal floor cleaning. Position two setting should be used when using attachments or for cleaning high traffic areas.

A three position switch in the handle (offered on some models) will indicate if your cleaner offers this ESP feature.

6