Enlarge the hole in the exterior wall to accommodate the inlet valve assembly (valve and mounting bracket). (As described above in “Installing an inlet valve.”) Inside the closet, drill a pilot hole through the floor beneath the opening in the wall or at a convenient spot nearby to check for obstructions. If there are no obstructions, cut a
Fig. 02
Inner-Wall Closet Assembly
Pass
(Fig. 03).
Fig. 03
Inner-Wall Closet Assembly – Installed
Floor valve installation.
To install a floor inlet valve, drill a pilot hole with a wire coat hanger and check the location as previously described. When you are sure that the proposed location will not be blocked by a joist or other obstruction, cut a hole in the carpet slightly larger than your
Multi-story homes.
Fig. 04
Two sets of tubing joining trunk line
Vidoe: 12:08
In a
drilling through the sole plate. Cut a
7