HOW TO ASSEMBLE
CAUTION: Assemble the cleaner before using. Moving parts, make sure on/off switch is in off (O) position before plugging in.
NOTE: Features may vary by model yet all parts assemble the same.
Attach Handle
CAUTION: Do not catch cord under handle.
1
Grooves
2
1.From rear of cleaner, align handle with groove and slide onto cleaner. If necessary, use thumb and fi nger pressure to slide handle into position.
2.Attach handle with the two 1 inch screws provided in the assembly packet. Use a Phillips® head screwdriver.
NOTE: Hand tighten with screwdriver to be sure both screws are firmly seated.
Attach Hose
3
Upper Hose
Retainer
4
Hose
Lower Hose Retainer
Store Hose and Accessories
Nested Wands
Dusting
Brush
Store Electrical Cord
Cord | 6 Cord Hook |
Retainer |
|
7 Plug
6 Cord Hook
5.You will fi nd your cord retainer on the handle above the upper cord hook. Firmly push the electrical cord down into the cord retainer. This will place the cord out of the way the next time you vacuum.
3.Pick up hose and lay across upper hose retainer.
4.Push the end of the hose in the lower hose retainer to secure.
6.Next wind the cord around the two cord hooks on the back side of cleaner.
7.Secure the plug to the cord to prevent unwinding.
4
