![Thermal Cut-Off](/images/new-backgrounds/83190/8319015x1.webp)
PN80238A english:OG english 12/16/08 4:08 PM Page 8
Thermal Cut-Off
This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum suddenly shuts off, push the power switch to off (O) and unplug the vacuum. Check the vacuum for a possible source of overheating such as a full dust cup, blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum. After the 30 minute period, plug the vacuum back in and turn on the switch. If the vacuum still does not work, take it to a Eureka authorized service center for repair or call
Problem Solving
!
Make sure vacuum is turned off and power cord is unplugged.
Problem | Cause | Solution | |
|
|
| |
Motor will not start. | Power plug | • Push plug securely into outlet. | |
|
| • Try another outlet. | |
|
| • Check circuit breaker. | |
|
|
| |
| Power switch | • Turn power switch to on ( I ). | |
| Thermal | • See above. | |
|
|
| |
Vacuum does not | Dust cup and filters | • Empty dust cup, clean and/or change filters. | |
clean carpet or bare |
| • If picking up fine dust, the dust cup may not look full, but | |
floor. |
| ||
| a fine substance tends to reduce suction when it blocks | ||
|
| ||
|
| air flow through the foam filter and filter screen. Refer to | |
|
| page 2 for filter maintenance. Make sure foam filter, filter | |
|
| screen and dust cup are installed properly. | |
|
|
| |
| Belt | • Replace a worn, cut or out of shape belt. Page 4 | |
|
|
| |
| Hose | • Remove any clogs from the hose that restrict the | |
|
| airflow. Page 5 | |
|
|
| |
| Bare floor setting | • For bare floor cleaning, turn height adjustment knob to | |
|
| bare floor position. | |
|
|
| |
| Carpet height setting | • For carpet cleaning, turn height adjustment knob to | |
|
| another position. | |
|
|
| |
No suction at the | Dust cup and filters | • Empty dust cup, clean and/or change filters. | |
end of hose. |
| • If picking up fine dust, the dust cup may not look full, but | |
|
| a fine substance tends to reduce suction when it blocks | |
|
| air flow through the foam filter and filter screen. Refer to | |
|
| page 2 for filter maintenance. Make sure foam filter, filter | |
|
| screen and dust cup are installed properly. | |
|
|
| |
| Filter screen | • (Located above the dust cup). Check & clean debris to | |
|
| maintain full air flow. Page 2 | |
|
|
| |
| Hose | • Remove any clogs from the hose that restrict the | |
|
| air flow. Page 5 | |
Vacuum is hard | Vacuum height setting | • Adjust knob to a higher position. | |
to push. |
|
| |
Belt | • Replace a worn, cut or out of shape belt. Page 4 | ||
| |||
|
|
| |
Burning smell; brush | Belt | • Check brush roll for debris. Page 4 | |
roll will not turn. |
| • Replace broken or out of shape belt. Page 4 | |
|
| ||
|
|
|
6 | Eureka Customer Service HELPLINE | www.eureka.com |