![](/images/new-backgrounds/1041935/4193533x1.webp)
HEMMING (Model 377 only)
Presser foot hemmer foot
Pattern selector
M( )
Stitch length dial | 1 to 4 |
Raise the foot and the needle to its highest position. Replace the foot with the hemmer foot.
Fold over the fabric edge by about 3mm (1/8 inches ) and place it under the foot. Secure the folded edge with a few stitches. Take out the workpiece and draw the hem into the hemmer foot by pulling on the threads.
Lower the foot and swe the hem.
During sewing, fold the fabric to the left a little and allow it to run into the hemmer foot.
Make sure that the fabric does not move under the right half of the foot. The fabric must be fed into the scroll of the hemmer sufficiently so that the workpiece edge runs freely through the groove under the foot.
hemmer foot
3mm
SEWING BLIND HEMS (Model 377/374/373/372)
Model 377 Model 374 Model 373/372
Presser foot | blind hem foot | blind hem foot | ||
Pattern selector | B ( | ) | E( | ) |
Stitch length dial | 1 to 3 |
| 1 to 3 |
|
1.Turn up the hem to the desired width and press. ( Fig. 1)
2.Fold hem back against the right side of the garment with top edge of hem extending about 4 mm (1/6 inches) to the right side of the garment folded. (Fig. 2)
3.Place the garment under the foot so that
Sew slowly for better control, making sure the narrow zigzag stitches are sewn on the hem edge and wide zigzag stitches will just catch one thread of folded edge. (Fig. 3)
4.Unfold the fabric and you will have a bling stitch hem (Fig. 4)
(Fig. 1)
,,
4mm (1/6 )
(Fig. 2)
Guide adjusting
screw(Fig. 1)
Guide
Foided edge
(Fig. 3)
(Fig. 4)
16