Operating Your EURO-PRO Steam Cleaner
Your
WARNING: With steam brush attachment assembled on unit - Do not press Steam Push Button more than once per second. Pressing steam push button quickly may cause hot water to accumulate between attachment and main unit which could then leak through crevice and burn user’s hand.0
Filling the Water Tank
WARNING: Always disconnect (unplug) the Garment Steamer from power source before filling with water.
The Water Tank is the blue translucent tank at the end of the Garment Steamer. See Fig. 2.
1.Remove the Tank by unscrewing it from the base unit by turning in a counter clockwise motion.
2.Remove the Water Tank base by turning in a counter clockwise motion.
3.With cool water*, fill Water Tank completely and then replace water tank base by turning in a clockwise motion until snug.
4.To reattach water tank to main unit, line up water tank fittings with fittings receptacles on main unit. Push water tank in, then turn in a clockwise motion.
*Note: We suggest mixing distilled water or demineralized water with tap water - 1part tap water to 3 parts distilled or demineralized water. Doing so will lengthen the life of the Steamer.
CAUTION: Never add anything except cool water or you will cause damage
CAUTION: Press steam push button intermittently no more than once every 1 or 2 seconds. Rapid pressing in succession will cause water leaking. Wait for steam pressure to reduce before pressing steam push button again. By pressing intermittently you will note a rhythm for maintaining a continuous flow of steam without any water dripping or leaking.
CAUTION: First usage may require
to the heating element. Use water only, any other liquid may be dangerous.
Power Cord
Before usage, remember to completely untangle or unwrap the full length of the power cord.
Power Light/Indicator Light
The red light will illuminate when power is on - (unit is plugged into socket), green light will go on and off during usage. Maximum temperature is achieved when green light is illuminated. Before pushing steam push button the first time per usage, wait until green light is illuminated. Following first usage, green light will go on and off. If too much water is exiting steam holes, you are pressing steam push button too rapidly. Stop pushing steam push button and wait for green light. Do not press steam push button more than once per second or once per 2 seconds.
Note: You may have some water exit on first burst. This is normal, just keep pushing the steam button intermittently and you will obtain a continuous flow of steam.
Note: You may have some water exit on first burst. This is normal, just keep pushing the steam button intermittently and you will obtain a continuous flow of steam.
4
Steam Push Button
The steam push button is pumping water to the heating element. Continuous steam can be attained if steam push button is depressed intermittently once every one or two seconds. You will notice a rhythm can be maintained while pressing steam push button which will maximize steam performance. Press steam push button and wait until you see steam pressure reduced then press steam push button again (approximately once every one or two seconds).
Important Note: After refilling or before each usage, it may take
5