OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
9.Reassemble the debris screen to the HEPA filter cartridge and replace into dust cup (container). Ensure that the filter assembly is completely seated inside the dust cup (container).
10.Attach the dust cup (container) to the vacuum.
PLEASE NOTE: The white pleated filter material in the HEPA Dust Cup Filter will discolor over time
is properly "TapCleaned” after each use and suction does not return to 100%, then we suggest that the HEPA filter be “TapCleaned” vigorously until no
more dust can be removed, then rinsed under the faucet and allowed to dry for 24 hours before refitting into the vacuum. (Fig. A) This should be done once a month or when suction appears to be reduced.
CAUTION: The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged.
Important: Do NOT use the HEPA filter cartridge without the debris screen in place.
Changing the Pre-Motor Filter
•Filter should be cleaned at least twice a year or when it becomes visibly solid.
•Always operate the cleaner with the filter installed.
•Disconnect from electrical outlet before cleaning the filter.
1.Lift dust cup handle to remove dust cup.
2.Remove the filter from the filter grill.
3.Replace with a new filter and reinstall in vacuum.
Changing the Micro-Exhaust Filter
1.Remove the exhaust filter grill by pulling the locking tabs towards you.
2.Remove the used
3.Insert a new
IMPORTANT: Both the
IMPORTANT: All filters should be checked regularly for signs of damage, preferable after each cleaning task. The filters must be replaced immediately if they become damaged.
Always disconnect the vacuum from the electrical outlet when checking the filters.
Assembling Your Vacuum Cleaner
Note: Always remove the power plug from the wall outlet before assembling or removing accessories.
1.Attaching the Flexible Hose into the Vacuum
Connect the flexible hose into the air intake duct. Push in until you hear a “click”, indicating it is in its locked position.
To remove the flexible hose reverse the operation.
Air Intake Duct
2.Fitting the Telescopic Tube to the Curved Wand / Hose Extension
Push the telescopic tube into the curved wand / hose extension, as shown in the illustration below.
3.Extending the Chrome Telescopic Tube
Push forward on the plastic button and pull the inner chrome tube outward.
Plastic
Knob
4.Fitting the Floor to Carpet Brush or the Air Driven Turbo Brush to the Telescopic Tube
Push the telescopic tube into the desired floor brush as show in the illustration below.
Telescopic
Tube
Floor to Carpet
Nozzle
5.Air Driven Turbo Brush
The efficiency of your Air Driven Turbo Brush depends on the bristle brush rotating at high speed. Strong air suction is needed to accomplish this. In order to endure that maximum air suction is maintained, please read the following instructions:
•Empty the Dust Cup frequently during use.
•Always “TapClean” the HEPA dust cup filter and debris screen each time the dust cup is emptied.
•Ensure that the rotating bristle brush is kept free of hair and string.
•Inspect the turbine regularly to ensure that the air passage is free of dirt and debris.
Hand Held Air Driven
Turbo Brush
Air Driven Turbo
Brush
7
4
