Euro-Pro HV118H owner manual Getting To Know Your Mini Canister Vacuum, Technical Specifications

OPERATING INSTRUCTIONS

GETTING TO KNOW YOUR MINI CANISTER VACUUM

IMPORTANT: In order to ensure that maximum air suction is maintained, empty the dust cup frequently and shake out the HEPA filter and Debris Screen at the same time. Ensure that the rotating brush is kept free of hair and string which may accumulate and decrease brush performance.

Cleaning Air Driven Turbo Brush

Locking Latch

Tilt

Upwards

Turbine

From time to time, the turbine of your turbo brush will require cleaning. To do this:

1.Remove the turbo brush from the hose or telescopic extension tube.

2.Slide locking latch forward then tilt the top housing of the brush upwards. The top housing is hinged and will tilt up approximately 45° only.

3.There may be some dust, lint, hair, etc on the turbine wheel. Remove as much of this as possible.

4.You may also use the unit’s hose with crevice tool attached and use the vacuum to remove any additional debris from the turbine.

5.Ensure that the turbine wheel moves freely by rotating it with your finger. If the turbine does not rotate, call Customer Service for help.

6.Once clean, close the top cover of the turbo brush and slide the locking latch toward the rear of the brush to lock.

Cleaning & Changing the HEPA Dust Cup Filter

WARNING: Always unplug the unit from electrical outlet before opening the Dust Cup (container).

IMPORTANT, Please Note : The “TapClean” Rinseable HEPA Dust Cup Filter & Debris Screen will stop most of the tiniest dust particles from re-entering the air you breathe. In fact it stops 99.97% of all particles as small as 0.3 microns - many times smaller than a human hair!!! Because of this incredible filtration performance, the HEPA Dust Cup Filter will quickly accumulate, inside the white filter folds, many fine dust particles that are difficult to see but which will eventually block or reduce your suction power - if not cleaned properly. Clean the HEPA Filter and Debris Screen after each use as described in this section.

1.To open the Dust Cup (container), push the dust cup release button and pull out the Dust Cup (container ).

2.Press the dust cup trap door release button to empty the dirt into a trash can.

3.To remove the HEPA filter from the dust cup container hold the dust cup in one hand and insert one finger of your other hand into the inlet hole on

the dust cup cover and pull it up.

19

1.	On/Off Power Switch	11.	Dust Cup Handle
2.	Hose Release Button	12.	Flexible Hose
3.	Dust Cup Release Button	13.	Floor Brush
4.	Dust Cup (Container)	14.	Deluxe Brush With Removable
5.	Caddy		Bristles
6.	Exhaust Filter Cover	15.	Extension Tubes (x3)
7.	Main Unit	16.	Crevice Tool

IMPORTANT: Do NOT use the HEPA dust cup filter without the debris screen in place.

WARNING: After each Use - Always remove the Filter Debris Screen from the HEPA Dust Cup Filter, then vigorously “TapClean” HEPA Filter until no more dust can be removed.

4.When the HEPA Filter assembly is removed from the dust cup, pull off the debris screen first. Then to remove the HEPA Filter from the Dust Cup Cover, hold the HEPA filter with one hand and with the other hand

pull the dust cup cover

6up.

8.	Intelli-Sense Filter MonitorTM	17.	HEPA Dust Cup Filter
9.	Shoulder Strap Attachment Points	18.	Debris Screen
10. Dust Cup Trap Door Release		19.	Air Driven Turbo Brush
	Button	20.	Shoulder Strap

	Illustrations may differ from actual product.
Technical Specifications
Voltage:	120V., 60Hz.
Power:	8.33 Amps
	3