Euro-Pro S3306H owner manual Operating Instructions, Attaching the Shoulder Strap, Components

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Attaching the Shoulder Strap

Using the detachable shoulder strap allows for greater freedom of movement when both hands are needed for various cleaning tasks. To attach the shoulder strap to the steam cleaner, simply snap the shoulder strap hooks onto the connecting rings on the unit body. (Fig. 9, 10 & 11)

Connecting

points

Connecting

points

Fig. 8 Fig. 9

Fig. 11

Important: When using the steam cleaner with the shoulder strap, avoid rocking or tilting the unit excessively as this may cause water to enter the hose and be discharged along with the steam.

Components

On/Off Power Switch: The On/Off switch has a light that will illuminate when the unit is plugged into the 120V wall outlet and the switch turned to the “On” position.

Steam Ready Light: The steam ready light located on the handle will turn “On” when the steam is ready.

Caution: Read the instructions for “Filling the Water Tank” before opening the Safety Cap.

Caution: Always unplug before filling.

ALLOW UNIT TO COOL FOR FIFTEEN (15) MINUTES BEFORE REFILLING.

Important: Do NOT add cleaning solutions, scented perfumes, oils or any other chemicals to the boiler in this appliance. Use tap water or distilled water if the tap water in your area is very hard.

Filling or Refilling Your Steam Cleaner With Water

Important: Always insure that the unit is “UNPLUGGED” from the wall receptacle prior to initial filling or re-filling the water tank and has been allowed to cool for 15 minutes. Never attempt to fill this unit under a water tap, always use the filling funnel provided.

1.	Remove the plug from the electrical
	outlet and allow the steam cleaner to
	cool for fifteen (15) minutes.
2.	Press the steam trigger on the hand grip
	to vent any residual steam pressure that
	is in the boiler.
3.	Place the unit on a flat, stable surface.
	Push down firmly on the safety cap
	and slowly turn the safety cap counter
	clockwise until it is removed.

Fig. 1

Warning: Extreme care should be taken when refilling the unit. Allow unit to cool for 15 minutes and vent any residual steam pressure (see Step #2) from the boiler before refilling. When refilling the steam cleaner while the boiler is still hot, there is a risk that water will squirt back during filling and cause scalding. Use caution when opening the Safety Cap as cap may become hot during use and escaping steam can cause scalding.

5.Connect desired attachments onto the flexible steam hose.

6.Plug the unit into a standard (120 volt, grounded) wall receptacle and switch the On/Off switch to the “On” position. Allow approximately 4-6 minutes for vapor to reach its working temperature and pressure. When the unit is ready for use, the steam ready light will turn “On”. Always point nozzle outlet in a safe direction. At the start, some water

will come out from the nozzle. This is normal.

Note: When the steam cleaner has run out of water, steam output will cease.

7.When finished using the unit, turn it “Off” and unplug it from the electrical outlet.

Fig. 10

4. Place the funnel in the tank opening.

(Fig. 1) Fill with a maximum of one

filling flask or 2 cups (500 ml) of water.

Do Not Overfill. Turn the safety cap

clockwise to replace.

Note: To remove or replace the safety cap, push down on it firmly and rotate it clockwise to tighten or counter clock-wise to loosen. If not depressed the cap will rotate freely without advancing.

Note: Filling the unit with hot water will shorten the heat up time.

Warning: This appliance is under pressure. After every use, press steam trigger button until all pressure has been released before removing safety cap. Allow unit to cool for fifteen (15) minutes before refilling.

8

5