OPERATING INSTRUCTIONS
4.Carefully lift out the battery pack and disconnect the wire terminals by pulling apart the wire terminal connectors. Remove the battery pack from the unit. (Fig. 5)
Wire Terminal Connector
Fig. 5
5.Connect the wire terminal connector from the unit to the wire terminal connector of the new battery pack, and replace the battery pack into the unit. Replace the cover and press until it snaps in place.
6.Follow instructions for initial battery charging. Please call customer service at 1 (800)
Do NOT attempt to replace the batteries used in this product with any other type of battery.
Important: This appliance contains
6
OPERATING INSTRUCTIONS
How To Operate Your Cordless Sweeper
1.Before using, please ensure that the cordless sweeper has been initially charged for 20 hours.
Your cordless sweeper will only operate properly when the batteries are fully charged. Your sweeper will operate for varying lengths of time on a full charge. This will depend upon the type of surface being cleaned. (Longer operating time on bare floors vs. carpets.)
2.Push the On/Off switch to operate the unit. To turn off, press switch again. (Fig. 6)
"On/Off“ switch
Fig. 6
3.To release the handle to a comfortable position, gently apply pressure to the top of the sweeper head with your foot while pulling back on the handle. (Fig. 7)
Fig. 7
4.To change the speed of the sweeper, press on the speed control button. As you press on it, the speed indicator light will change. If one light lights up, you have the low speed for hard floors; two lights, medium speed for carpeting; three lights, high speed for turbo deep cleaning. (Fig. 8)
Hard floors |
|
Carpeting |
|
Turbo Deep | Fig. 8 |
Cleaning |
|
Anti-Jam Brush Roll Feature
This feature protects your unit’s motor from damage due to overheating, that may be caused by the rotating brush getting jammed or tangled in something. If the rotating brush becomes overloaded it will stop turning and both speed indicator lights will remain flash at the same time. To reset the unit:
1.Press On/Off switch.
2.Remove the transparent brush cover from the sweeper power head to remove any build up of lint, hair or fiber on the rotating brushes.
3.Wait for 10 seconds to allow the unit to cool down.
4.Press On/Off switch again, the unit should restart.
7
