To Maximize The Life Of Your Ni-cdBatteries

1. Charge for a minimum of 20 hoursbefore initial use. Failu re to do so will reduce
the product’s battery life significantly.
2. Do notstore the unit with the charging adaptor attached and plugged in.
3. Only recharge when the batteries are fully discharged (or as close to fully
discharged as possible).
4. Do notstore in areas of high temperatur e or humidity.
5. After three (3) months of storage, the product should be fully discharged and then
recharged to maximize battery power.
6. Use only the charger supplied with the product. If other chargers are used, the
batteries can fail causing damage to the battery, product or personal property.
7. Ni-Cd b atteries have a long useful life but at some time they will need to be
replaced. To purchase replacement batteries and parts call customer service at:
1 (800) 798-7398.
Note: If the product has never been used or has been stored for an extended period
of time without use –it will take several complete charge and discharge cycles to
realize the full operational time of your product.

Battery Removal & Disposal

Note: If uncertain as to how to remove your battery pack, we suggest you take your

sweeper to a reputable small appliance service technician to have this service
performed.
Follow the steps in “Removal of Battery Pack when battery removal is required.
This sweeper is equipped with Ni-Cd batteries and you need to dispose of them
properly. When the batteries are no longer good for use, they must be removed from
the sweeper for disposal. Do notremove the batteries for an y reason other than
disposal of them. Call your nearest recycling center for information on the
recycling and disposal of Ni-Cd batteries.

Warning:You must never use ordinary batteries for replacement as these may leak

and cause damage. Use only battery pack XBV1925H provided for replacement.
5
Operating Instructions Operating Instructions
6

Removal of Battery Pack

1. Turn unit over so that the base is facing upwards.
Be careful not to turn the unit ON.
2. Push in locking tab and lift off the battery compartment cover. (Fig. 3)
4. Connect the wire terminal connector from the unit to the wire terminal connector
of the new battery pack, and replace the battery pack into the unit. Replace the
cover and press until it snaps in place.
5. Follow instructions for initial battery charging. Please call customer service at
1 (800) 798-7398 if there are any problems removing batteries.
DO NOT ATTEMPT TO REPLACE THE BATTERIES USED IN THIS PRODUCT
WITH ANY OTHER TYPE OF BATTERY.

Important:This appliance contains Ni-Cd batteries. The batteries must be

recycled or disposed of in accordance with local regulations. Please consult
your Yellow Pages or local recycling center for more information.
Fig. 3
Wire Terminal Connector
Battery Pack
Compartment Cover
Locking Tab
3. Carefully lift out the battery pack and disconnect the wire terminals by pulling
apart the wire terminal connector. Remove the battery pack from the unit. (Fig. 4)
Fig. 4