OPERATING INSTRUCTIONS
8.Slip the belt over the brush bar cap.
9.Insert the brush bar into the slot. (Fig. 14)
10.Insert the gear box tabs into the tab slots and push down until it clicks into place.
11.To replace the squeegee, follow instructions above for removing the gear box and slide the squeegee out from left to right. (Fig. 16)
Fig. 16
Care And Maintenance
To improve the performance and life of your unit, we recommend you do the following:
1.Periodically remove the transparent brush cover on the front of the cordless sweeper and remove any build up of lint, hair or fiber on the rotating brush.
To remove the cover - grip the cover from the bottom, pull out and upward until the cover unlocks from the side slots and tabs located on the top of the sweeper. Carefully cut away threads or hair with scissors. (Fig. 17)
Fig. 17
2.Once a month clean the unit with a dry cloth, including the chamber which the dust cup container fits into. Remove any hair, fiber or other materials that may have built up in the chamber, and on the rotating brush.
3.Don’t use abrasive materials to clean the sweeper. Do not immerse the unit in water.
4.Do not pick up liquids or use on wet floors.
5.Do not use on concrete, tar or similar rough surfaces.
6.Don’t pick up pieces of string or fabrics with the sweeper.
7.Do not clean tasseled or frayed carpets with the sweeper.
Caution: Do not accidentally turn unit on while cleaning.
Caution: Any electronic or electrical appliance should not be stored in or exposed to areas of high heat or humidity. Do not store your cordless sweeper close to stoves, radiators, furnaces or in a bathroom or bathing area.
OPERATING INSTRUCTIONS
Assembling Your Cordless Sweeper
Your cordless sweeper will require very little assembly. You should remove it from the carton and familiarize yourself with all the components listed per the exploded view drawing. (Pg. 2) This will help you in the assembly and operation of your cordless sweeper.
Note: The charging adapter will be shipped inside the foam packaging.
Note: The lower handle extension tube has a different plastic insert. This tube should be the first on the assembly.
1.Insert the lower extension tube into the steering pivot so that the tab snaps into place. (Fig. 1a) Push the telescopic tube into the lower extension tube. (Fig. 1b) Insert the handle into the telescopic tube. (Fig. 1)
Insert into
Lower
Handle
Fig. 1b
Fig. 1a
Fig. 1
2. Place the handle into the upward storage position.
10 | 3 |
