OPERATING INSTRUCTIONS
4.The telescopic tube is designed to adjust to the height that is comfortable for all users. To adjust the height, simply push down the release button on the telescopic tube and pull the handle to adjust to a comfortable height for using. (Fig. 2)
OPERATING INSTRUCTIONS
Changing The Rotating Brush, Gear Box & Squeegee
1. | Remove the extension tube handle from the sweeper power head. |
2. | Turn the sweeper power head upside down being careful not to accidentally turn |
| the unit “On”. |
3. | Remove the brush cover. |
Charging Instructions
Release
Button
Fig. 2
4. Push in on the locking tab of the gear box and lift the gear box to remove. |
(Fig. 12 & Fig 13) |
Lift
Gear box | Locking |
tab |
1.Connect the charger plug to the charging jack or hole at the rear of the sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only Ktec model KA12D090015023U. (Fig. 3)
Charging
Light
Indicator
Fig. 3
2.This cordless sweeper is powered by
3.When recharging the unit, the "On/Off" switch must be in the "OFF" position.
4.The charging light indicator on the top of the sweeper will illuminate to indicate that the sweeper is properly charging.
5.To recharge, repeat step #1 above. Charging times will vary depending upon the amount of usage between charging cycles.
Note: If when you place the sweeper to recharge and the charging indicator light does NOT illuminate, then press the On/Off button once to turn the sweeper off. The charging indicator light should now light up.
Note: Peak performance may only be realized after the unit has been charged and discharged two (2) or three (3) times.
Important: To maintain peak performance of your cordless sweeper, it is recommended that the unit be fully discharged, then completely
Caution:
•Use only the adaptor supplied with the sweeper.
•This power unit is intended to be correctly orientated in a vertical or floor mount position when charging.
•Do not clean the sweeper while unit is charging.
•Do not attempt to remove the battery pack from the unit to charge it.
•Never attempt to throw the battery pack or unit into a fire or incinerate it.
•Do not attempt to remove or damage the battery casing.
4
Gear box
tabs | Fig. 12 | Fig. 13 |
|
5.Lift the brush bar end cap up from the slot. (Fig. 14)
Fig. 14
6.Pull the brush bar out from the bushing and slip off the belt to remove the brush bar. (Fig. 15)
7.Insert the new brush bar by first inserting the brush bar into the bushing on the end opposite the driver belt (Fig. 15)
Fig. 15
9
