THE CONTROL PANEL

The control panel on your Eurotech tumble dryer is easy to understand and simple to operate.

START

DELICATE

NORMAL

ON/OFF

ON/OFF BUTTON

This button turns the power to the machine on and off. The power must be on before you can start a program.

DELICATE/NORMAL BUTTON

This button lets you select between a normal and low drying temperature.

NOTE: Always refer to the care label on the garment to determine if it can be tumble dried. (See page 9.)

Normal: The Normal temperature setting is for sturdy fabrics, such as cotton, linen, and denim. If this button is not pressed in, the temperature setting is Normal.

Delicate: The Delicate temperature setting is for synthetics, such as cotton/polyester blend, rayon, acetate, washable silk or nylon. If this button is pressed in, the temperature setting is Delicate.

PROGRAM KNOB

To select a program, turn on the power then turn the program knob to the desired program. Wait for a short beep, then press Start. After a brief pause, the program will begin.

The programs on the right of the dial are for cottons and linens. The programs on the bottom are for synthetics. You can also set a Timed Dry program (on top left of dial) for 60, 40 or 20 minutes.

NOTE: The dryer will not start unless the door is closed securely and there are no items caught between the door and the rubber gasket.

START BUTTON

After you have select the desired program and temperature option and heard the beep, press this button to start the machine. The power must be on before you can start a program.

INDICATOR LIGHT AND END-OF-PROGRAM TONE

When you press the On/Off button, the indicator light below the program knob comes on and stays on during the program. At the end of the program, the light flashes and an end-of-program tone sounds to indicate the program is complete. This continues until the door is opened or the program knob is turned to the 12:00 position.

COOL-DOWN

Every program ends with a cool-down cycle that is designed to reduce wrinkling. This means the clothes will be cool when you remove them from the dryer, rather than scorching hot. After the cool-down cycle ends, the light flashes and an end-of-program tone sounds to indicate the program is complete .

10

Page 10
Image 10
Eurotech Appliances EDV278EL owner manual Control Panel