APOLLO 1U ICE

Internal configuration

 

 

Remove any cables attached to installed PCI expansion cards before attempting removal of the PCI module.

To remove the PCI Module, follow these steps:

1Unplug the flexible riser connection to the APOLLO SBC.

Take care to pull on the plug-in connector rather than the flexible cable.

2Disconnect the tamper detect cable from front panel breakout board assembly.

The PCI module is retained in the enclosure by formed lugs on the base, and one retaining screw.

3Unscrew the retainer and slide the PCI Module back to clear the lugs on the base, and lift out.

Be careful of the tamper detect switch and cable when the PCI module is removed.

To fit a PCI card:

1Remove the blanking plate.

2Plug the card into the riser.

3Adjust and fix the support bracket to suit.

4Tighten the retaining screw.

To install the PCI Module, reverse the procedure outlined above.

© 2007 Eurotech Ltd Issue C

23