1LINE 1 INPUT This jack accepts a ¼” TRS connector, wired either balanced or unbalanced.
For balanced wiring, a
Unbalanced wiring works with either a 2 or
The LINE 1 INPUT connector is hardwired in parallel with the LINE 2 INPUT connector, so either may be used as an input or a
2INPUT SENSITIVITY This control has a 20dB range and compensates for different input signal levels. If too much input signal is present, the amplifiers may overload, in which case the green LED at the front of the monitor will flash. With the INPUT SENSITIVITY control at maximum, 0.9V RMS input will produce full amplifier output.
The PS5 monitor has an additional front panel VOLUME CONTROL (not shown) that effectively works in series with the rear panel INPUT SENSITIVITY control. The VOLUME CONTROLis useful for quick, uncalibrated adjustments from the front. With a full input signal applied, turn the front panel VOLUME CONTROL to maximum. Starting from minimum, increase the INPUT SENSITIVITY to your maximum achievable output level preference. The front panel volume control will then attenuate from that operating point.
3LINE 2 INPUT This jack accepts XLR input connections, wired either
4
5
balanced or unbalanced. The LINE 2 INPUT connector is hardwired in parallel with the LINE 1 INPUT connector, so either may be used as an input or a
3
POWER SWITCH 1 = ON 0 = OFF
When amplifier power is on, the green LED at the front of the monitor will illuminate.
POWER CONNECTOR This connector accepts the detachable linecord. Use the linecord supplied with your monitors and make sure it is fully seated into the Power Inlet connector. For safety reasons, do not attempt to defeat the linecord’s ground connection. The AC mains fuse is internal.