![](/images/new-backgrounds/1061536/615363x1.webp)
ENGLISH
TOOLS REQUIRED FOR INSTALLATION:
•Phillips Screwdriver
•Adjustable Wrench
•Tape Measure
•Pencil
Basic Installation Instructions
1.Open Carton & Inspect Parts
Installation Parts
Key | Description | Part No. |
1 | QL3 Filter Head | |
2 | ||
3 | 2 Locking Washers | |
4 | 2 Screws | |
5 | 3/8" MPT x 3/8" FTP Elbow | |
6 | (2) 3/8" x 1/2" Unions | |
7 | (2) 3/8" x 3/8" Unions | |
8 | Tubing, 3/8" Braided | |
9 | Teflon® Tape | |
10 | Everpure Filter Timer | |
|
|
|
2. Verify Under-Sink Mounting Location
Measure 20” from the base of the cabinet, and mark the mounting location for the top of the filter head. Make sure there is adequate space above the head to open and close the built in
DIMENSION | Width | Mounting | Depth | |
Height | ||||
|
|
| ||
5" | 20" | 5" |
NOTE: The head and cartridge must be mounted in the vertical position, with the cartridge hanging down.
1
4 5 3
1
2 | 6 | 7 |
|
| |
8 | 10 |
|
|
| |
com.everpure .www | MONITORFILTER WATER | 9 |
|
|
2
20"
3. Mount Filter Head Under Sink
NOTE: Two sets of unions are included to connect to the
The following instructions are for a typical installation using
A. Apply Teflon Tape to the small threads of one Union Fitting and |
screw into the open end of the Elbow. Wrap tape in direction of the |
threads to assure a tight fit and avoid small leaks. |
B. Apply Teflon Tape to the threads of the Elbow Fitting and screw |
into the inlet (left) side of the Filter Head. Hand tighten only. |
C. Apply Teflon Tape to the small threads of the second Union Fitting, |
3A
C
B
D |
| and screw into the right side of the filter head in the same manner. |
D. | Securely mount the filter head on the cabinet wall using the |
| enclosed mounting screws and washers. |
4. Connect Inlet Water Supply | |
E. | Locate and close the cold water |
| Open cold water line of faucet to release water pressure. |
F. | Unscrew and disconnect the braided tubing on top of cold water |
| |
G. | Attach one end of the new braided tubing to the top of the cold |
| water |
H. | Attach the other end of the new Braided Tubing to the inlet side of |
| the filter head (Union & Elbow Fittings). |
4 |
F |
E |
H |
G |
• •