Evolution Technologies 361, 249 manual Slider Assign, Pitch Bend Wheel, Wheel Assign

8.SLIDER ASSIGN

Moving the SLIDER transmits MIDI CONTROL CHANGE messages to any connected equipment. The Slider defaults to sending Channel Volume messages on the selected channel, but you can re-assign the slider to any other controller.

Number	Functions
1 – 127	Standard MIDI controllers
128	Pitch Bend Sensitivity
129	Fine Tune
130	Coarse Tune
131	Channel Pressure
132	Velocity

With Evolution 249/361. Press the SLIDER ASSIGN switches (PROGRAM & BANK LSB) together and the LED starts to flash showing the number of the present MIDI controller.

Use numeric keys 0-9 to select a new MIDI controller. You can also use the +/- switches to increase or decrease the value of the number.

With Evolution 225C/249C/361C. Press the CONTROL SELECT switches (MEMORY & PROGRAM) and the LED starts to flash showing the number of the present MIDI controller.

Move the slider. Alternatively, press numeric keys 0-9 to select a new MIDI controller. You can also use the +/- switches to increase or decrease the value of the number. The LED display should flash C13.

Note: * If you do nothing for 3 seconds, the LED will return to show the current PROGRAM CHANGE number.

*If the number you press is not in the range of defined numbers, the previous number will be retained.

*When you assign 120 or 121 as the MIDI controller for the WHEEL, you should move the MODULATION Wheel to the mid-value then return it to the minimum value to send a relative MIDI message.

See Appendix B for a full list of controller numbers.

9.PITCH BEND WHEEL

Moving the PITCH BEND WHEEL transmits MIDI PITCH BEND messages to any connected equipment. This allows you to bend the pitch of a sound up (or down one tone) to add expression to your performance.

To bend the sound up: Move the WHEEL away from you.

To bend the sound down: Move the WHEEL towards you.

10.WHEEL ASSIGN

Use the WHEEL to transmit MIDI CONTROL CHANGE messages. You can select and assign 119 types of MIDI functions (1-31, 33-95, 102-121, 128-132)

Number	Functions
1 –127	Standard MIDI controllers
128	Pitch Bend Sensitivity
129	Fine Tune
130	Coarse Tune
131	Channel Pressure
132	Velocity

With Evolution 249/361. Press the WHEEL ASSIGN switches (MEMORY & PROGRAM) together and the LED starts to flash showing the number of the present MIDI controller.

Use numeric keys 0-9 to select a new MIDI controller. You can also use the +/- switches to increase or decrease the value of the number.

With Evolution 225C/249C/361C. Press the CONTROL SELECT switches (MEMORY & PROGRAM) and the LED starts to flash showing the number of the present MIDI controller.

Either move the wheel, or press numeric keys 0-9 to select a new MIDI controller. You can also use the +/- switches to increase or decrease the value of the number. The LED display should flash C14.

Note: * If you do nothing for 3 seconds, the LED will return to show the current PROGRAM CHANGE number.

*If the number you press is not in the range of defined numbers, the previous number will be retained.

*When you assign 120 or 121 as the MIDI controller for the WHEEL, you should move the MODULATION Wheel to the mid-value then return it to the minimum value to send a relative MIDI message.

*See Appendix B for a full list of controller numbers.