Excalibur electronic 402-1 manual Batteries

Congratulations on the pur- chase of your Excalibur Electronics’ Space Invaders!

To get the most fun from your new game, please read this operating manual thoroughly, paying special attention to safety and care instructions.

Your	Space	Replacing	Batteries
		Invaders	driver to remove the
game	comes	with 2	screw. Lift off the bat-

Layout of Space Invaders

OPEN

<CURSOR > CURSOR

PAUSE	START
SOUND	FIRE
ON/OFF	RESET

Function of Buttons

AG13 batteries already					tery	compartment				lid.
installed. To			activate		Install 2 AG13 batter-
the batteries,			pull	the	ies,	making			sure	to
tab extending from the					match		the	polarity		(+
battery		compartment			and -) with the diagram
on the back of the unit.					inside the battery com-
When		you	need	to	partment.			Place		the
					tabs		of	the	battery
replace		the batteries,			compartment				lid	in
carefully turn the game					their slots and snap the
over so that the top					compartment				door	on
side is face-down on a					again.		Replace			the
soft	surface.		Use	a	screw and tighten gen-
small	Phillips screw-				tly.

Your Space Invaders but- tons are easy to use. OPEN Press this tab to open the screen.

< CURSOR Press this key to move your cannon to the left.

> CURSOR Press this key to move your cannon to the right.

PAUSE Press to stop the game temporarily. SOUND Press this key to

turn sounds on and off. ON/OFF Press to turn the unit on and off.

FIRE Press to fire your cannon at the invaders or to begin your game.

START Press this key to start your game or to fire your cannon.

RESET Use a ballpoint pen to push this button (on the back of the game) if your game locks up or functions improperly.

2 3