Excalibur electronic H630S How to Use, Charging the Forever, Flashlight Rip Cord, Diagram, page

	How to Use
Charging the Forever		Charging your unit
Flashlight Rip Cord		using your built-in
Your Forever	Flashlight	rechargeable batteries.
		It is charged by pulling
Rip Cord includes two great
options to charge your unit.		the RIP CORD on the unit.
For directions	on each	Your RIP CORD is located in
option see right:		the rear of the flashlight
		under the RUBBER BACK
		COVER. For best results, fol-
		low these steps in charging:
		1. Turn the unit off.

Diagram 1

6.6 LBS

Important. It is suggested that pulling the RIP CORD should not be allowed to go past the red color of the cord. This will damage the unit and not allow for

maximum electricity. 6

2. Lift the RUBBER BACK
COVER and locate your				RIP
CORD.
3. Hold the unit parallel
to the ground and pull the
RIP CORD. To achieve a par-
tial charge, pull the				RIP
CORD	approximately			80
times in one minute. Please
note, keep the unit parallel
and pull RIP CORD straight.
The charge will not be
effective, if the RIP CORD is
pulled at an angle greater
than 30º (see Diagram 1,
page 6).				at a
Pull	the	RIP	CORD
speed of approximately 80
times per minute. This will
provide 20-30 minutes of
flashlight		light	and	one

minute of cell phone time.
The pulling force for the RIP
CORD must be constant and
of moderate speed.	7

It is recommended to charge your Forever Flashlight Rip Cord for three to five minutes either before the first time you use it or after a long period of non-use of your unit.

NOTES:

• Important. It is sug- gested that pulling the

should not be allowedRIP toCORDgo past the red color of the cord. This will damage the unit and not allow for maximum electricity.

• While pulling the

of the ForeverRIP

FlashlightCORD Rip Cord, an indicator light will be on. This will signify that the charging is in the process.