Styling tips
Brush hair thoroughly before setting. Divide your hair up into small sections, and deal with them separately piece by piece as described below until the desired result is achieved.
Creped hair:
oStart with a lock of hair about 5 cm wide and close the crepe iron’s ceramic plates (11) around the hair near the scalp.
o Keep the plates closed for approx. 10 seconds.
oOpen the plates and close them again further along the lock of hair.
Flat, smooth hair:
oStart with a lock of hair about 5 cm wide and close the crepe iron’s ceramic plates (11) around the hair
near the scalp.
oSlowly slide the apparatus towards the hair ends in a fluent movement. Keep the hair tight to avoid kinks. For more lift in the hair, smooth only the outer part of the hair lock.
Hair with a flick:
oStart with a lock of hair about 5 cm wide. Close the curling iron (12) around a lock of hair with the upper
jaw at the back close to the scalp.
oSlide the apparatus slowly towards the hair ends. o Finish by curling the last piece of hair a little out at
the ends.
Hair with a curl:
o Start with a lock of hair about 5 cm wide. Close the curling iron (12) around a lock of hair with the upper jaw at the front close to the scalp.
oSlide the apparatus slowly towards the hair ends. o Finish by curling the last piece of hair under at the
ends.
Curls:
oStart with a lock of hair about 5 cm wide. Open the upper jaw (12) and place it about halfway along the
lock of hair.
oSpread the hair along the cylinder and carefully release the upper jaw so that the hair is trapped.
oSlide the apparatus slowly towards the hair ends. o Check hair ends are trapped under the jaw and
finish by winding the lock around the curling iron towards the scalp. Avoid touching the scalp with the hot curling iron.
o Hold the curling iron in place for
o Open the jaw and remove the apparatus from hair. Allow hair to cool before setting.
Soft curls:
oSet brush accessory (13) on the thinnest curling iron (12) without opening the jaw. Important: The iron
must be cold before fitting the brush. o Heat the apparatus up.
oStart with a lock of hair about 5 cm wide and roll it around the brush. Start at the hair ends and roll
towards the scalp.
oHold the iron in place for approx. 10 seconds before carefully rolling the hair lock out again. Allow hair to cool before setting.
Long curls:
oSet spiral accessory (14) on the thinnest curling iron (12) without opening the jaw. Important: The iron
must be cold before fitting the spiral. o Heat the apparatus up.
oStart with a lock of hair about 5 cm wide and roll it around the spiral. Start at the hair ends. Trap them with the small jaw and roll towards the scalp.
oHold the iron in place for approx. 10 seconds before carefully rolling the hair lock out again. Allow hair to cool before setting.
CLEANING
•Remove the plug from the socket before cleaning.
•Allow to cool down before cleaning.
•Do not use strong or abrasive cleaning agents, solvents or similar to clean the apparatus, as these may scratch or damage the external surfaces and the ceramic plates.
•Instead, wipe with a soft dry cloth.
•Never submerge the apparatus in water, and no water must be allowed to get into it.
INFORMATION ON DISPOSAL AND RECYCLING OF THIS PRODUCT
Please note that this Adexi product is marked with this symbol: 
This means that this product must not be disposed of together with ordinary household waste, as electrical and electronic waste must be disposed of separately.
In accordance with the WEEE directive, every member state must ensure correct collection, recovery, handling and recycling of electrical and electronic waste. Private households in the EU can take used equipment to special recycling stations free of charge. In some member states you can, in certain cases, return
the used equipment to the retailer from whom you purchased it, if you are purchasing new equipment. Contact your retailer, distributor or the municipal authorities for further information on what you should do with electrical and electronic waste.
13
