•Empty the dust container (8) after each vacuuming (see the section on "Emptying the dust container and cleaning the filter” below).
•Replace the appliance for charging in the charging station once you have finished using it. Remember to turn of the power to the charging station after charging the appliance!
Using the
•Take the hand held vacuum cleaner out by pressing the two release buttons (4) and pulling the hand held vacuum clear upwards.
•Start the hand held vacuum cleaner by pushing the on/off button (5) forward.
•Empty the dust container after each vacuuming (see the sec- tion on "Emptying the dust container and cleaning the filter” below).
•Place the
Important!
Always ensure the dust filter (9) is fitted. You must never vacuum without a filter or when a filter is damaged. If you do, dust may penetrate into the interior of the vacuum cleaner and damage the motor.
DUST CONTAINER AND FILTER
This appliance is not equipped with a dust bag. The dust/dirt is sucked up into the transparent dust holder instead. Once the dust is in this container, it whirls around so that it does not block suction. The air sucked in is cleaned by means of a
Emptying the dust container and cleaning the filter
The transparent dust container is to be cleaned after or during each vacuuming if the container is filled up..
1.Turn off the appliance.
2.Take the
3.Turn the
4.Remove the dust container from the
5.Take the dust container to a dustbin.
6.Pull the two parts of the filter out of the dust container and empty the container. If necessary, rinse the dust container with clean water and wipe the container with a dry cloth.
7.The filter consists of two sections, both of which must be cleaned. Brush the sections with a small brush or wash them in lukewarm water without any detergent or similar.
8.Allow the parts of the filter to become completely dry (do not dry in the sun or with a hairdryer).
9.Place the top part of the filter on the bottom part, and place the filter in the dust container of the apparatus again. The top part of the filter must cover the opening of the nozzle in the bottom of the dust container.
10.Take care not to damage the filter, and ensure that it covers the nozzle opening over the dust container, as otherwise the motor or other parts of the appliance may become damaged.
11.Place the dust container on the
TRANSPORT AND STORAGE
•You can lift and carry the appliance using the foldable handle.
•Before storing the apparatus, the
•To save space, the handle can be folded by pressing the release button(3).
CLEANING
•Clean the appliance by wiping it with a damp cloth.
•You must not use any form of solvent, or strong or abrasive cleaning agent.
•Make sure the filter is kept clean (see above). Replace the filter once it becomes worn or can no longer be cleaned.
Cleaning the brush on the nozzle
There is a rotating brush in the floor nozzle (14). The brush must be cleaned if it becomes covered in hair or other substances.
1.Turn off the appliance.
2.Take the floor nozzle off of the appliance by pressing the release button (12) and pulling off the floor nozzle.
3.Turn the floor nozzle so that you can see the rotating brush.
4.Loosen the screw on the bracket that holds the brush in place with the appropriate screwdriver.
5.Lift the bracket carefully by pul- ling it towards the screw hole and slightly upwards.
6. Pull gently the belt off the brush.
7.Afterwards, lift the brush out of the floor nozzle.
8.Remove hair, fibers and dust from the brush.Then place the brush back in the floor nozzle so that the end of the brush where the belt drive is located is on the same side as the bracket. Place the belt on the belt drive and screw the bracket onto the floor nozzle
9.Rotate the brush to make sure that it is correctly attached.
15