Maintenance
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
WARNING
While maintenance or adjustments are being made, someone could start the engine. Accidental starting of the engine could seriously injure you or other bystanders.
Remove the key from the ignition switch, engage parking brake, and pull the wire(s) off the spark plug(s) before you do any maintenance to the unit or StandOn. Also push the wire(s) aside so it does not accidentally contact the spark plug(s).
Recommended Maintenance Schedule(s)
Maintenance Service | Maintenance Procedure | |
Interval | ||
| ||
|
| |
Before each use or daily | • Inspect the StandOn. | |
• Check for dirt/mud buildup between tire and fender. | ||
| ||
|
| |
Every 25 hours | • Grease pull arm pivot. | |
|
| |
Yearly | • Grease caster wheel hub. | |
• Lubricate the caster wheel hubs. | ||
| ||
|
|
Periodic Maintenance
Inspect StandOn
Service Interval: Before each use or daily
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Inspect for loose hardware. Tighten any loose hardware.
3.Inspect for wear or damage daily. Replace or repair worn parts as needed before operating.
Check StandOn for Buildup
Service Interval: Before each use or daily
Check for dirt/mud buildup between tire and fender. Remove buildup before operating.
Lubricate Grease Fittings
Note: See chart for service intervals.
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Lubricate fittings with NGLI grade #2
Refer to the following chart for fitting locations and lubrication schedule.
Lubrication Chart
Fitting | Initial | Number of | Service |
Locations | Pumps | Places | Interval |
1. Pull Arm | 1 | Yearly | |
Pivot |
|
|
|
2. Caster | 0* | 1 | Yearly |
Wheel Hub |
|
|
|
14
