Setup

Choose the mount holes that will attain a distance of approximately 8 inches.

b. Install the adapter plates to the mower engine deck using two 3/8-16 x 1/4 inch hex capscrews and two 3/8-16 inch flanged nyloc nuts as shown in Figure 9.

Figure 7

1. Replacement decals

e.Align the pull frame and adapter plate assembly to the rear surface of the engine deck. Measure the distance from the bottom of the pull frame to the ground. Choose the mount holes that will attain a distance approximately 8 inches (20 cm).

Install the mount brackets to the mower engine deck using two 3/8-16 x 1 1/4 inch hex capscrews, two back-up plates, and two 3/8-16 inch nyloc nuts as shown in Figure 8).

Figure 8

1. 3/8-16 x 1 1/4 inch hex 3. 3/8-16 inch nyloc nuts capscrews

2.Pull frame and adapter plate assembly

B.For Turf Tracer HP and Metro HP Units:

a.Align the pull frame and adapter plate assembly to the rear surface of the engine deck. Measure the distance from the bottom of the pull frame to the ground.

Figure 9

1.3/8-16 x 1/4 inch hex capscrews

2.Pull frame and adapter plate assembly

3.3/8-16 inch flanged nyloc nuts

Mounting the Pull Arm and Platform

For Turf Tracer, Turf Tracer HP, Metro HP, and Viking Hydro Units:

1.Locate the pull arm assembly. Align the pull arm assembly with the pull frame as shown in Figure 10. Squeeze the quick connect pins on the pull arm assembly and attach the pull arm assembly to the pull frame.

11

Page 11
Image 11
Exmark 4500-435 manual Mounting the Pull Arm and Platform, For Turf Tracer HP and Metro HP Units