Maintenance
Figure 37
1.Feeler gauge
•If the gap is less than 0.010 inch, then reinstall the shim and reference the Troubleshooting section.
•If the gap is sufficient, proceed to the safety check in step F.
F.Perform the following safety check:
a.Sit on the seat and start the engine.
b.Make sure the blades Do Not engage with the PTO switch “off ” and the clutch disengaged.
If the clutch does not disengage, reinstall the shim and reference the Troubleshooting section.
c.Engage and disengage the PTO switch ten consecutive times to ensure the clutch is functioning properly. If the clutch does not engage properly, reference the Troubleshooting section.
Motion Control Linkage Adjustment
Located on either side of the fuel tank, below the seat are the pump control linkages. Rotating the pump linkage with a 1/2 inch wrench allows fine tuning adjustments so that the machine does not move in neutral. Any adjustments should be made for neutral positioning only.
WARNING
Engine must be running and drive wheels must be turning so motion control adjustment can be performed. Contact with moving parts or hot surfaces may cause personal injury.
Keep fingers, hands, and clothing clear of rotating components and hot surfaces.
1.Prior to starting the engine, push the deck lift pedal and remove the height of cut pin. Lower deck to the ground.
2.Raise the rear of machine up and support with jack stands (or equivalent support) just high enough to allow drive wheels to turn freely.
3.Remove the electrical connection from the seat safety switch, located under the bottom cushion of the seat. The switch is a part of the seat assembly.
4.Temporarily install a jumper wire across the terminals in the connector of the main wiring harness.
5.Start engine. Brake must be engaged and motion control levers out to start engine. Operator does not have to be in the seat because of the jumper wire being used. Run engine at full throttle and release brake.
6.Run the unit at least 5 minutes with the drive levers at full forward speed to bring hydraulic oil up to operating temperature.
Note: The motion control lever needs to be in neutral while making any necessary adjustments.
7.Bring the motion control levers into the neutral position. Adjust pump control rod lengths by rotating the double nuts on the rod in the appropriate direction until the wheels slightly creep in reverse (Figure 38). Move the motion control levers to the reverse position and while applying slight pressure to the lever allow the reverse indicator springs to bring the levers back to neutral. The wheels must stop turning or slightly creep in reverse.
48
