Exmark 920 Specifications, Model Numbers, Systems, Engine, Safety Interlock System, Fuel System

Models: 920

1 52
Download 52 pages 8.82 Kb
Page 15
Image 15
Specifications

Specifications

Specifications

Model Numbers

Serial Nos: 920,000 and Higher

PNS20KA443; PNS22KA483; PNS24KA523

Systems

Engine

Engine Specifications: See your Engine Owner’s Manual

Engine Oil Type: Exmark 4–Cycle Premium Engine Oil

RPM: Full Speed: 3750 ±50 RPM (PTO not

engaged) Idle: 1500 ±100 RPM

Safety Interlock System

PTO must be disengaged, brake engaged, and motion control levers out (neutral lock) to start engine. (It is not necessary for the operator to be in the seat to start the engine.)

Operator must be in seat when PTO is engaged, brake is disengaged, or motion control levers are moved in or engine will stop.

Engine will stop if either the left, the right, or both levers are moved from neutral lock position while brake is engaged.

Fuel System

Capacity: 7.0 gal. (26.5 L)

Type of Fuel: Regular unleaded gasoline, 87 octane or higher; containing no more than 10% methanol or ethanol.

Fuel Filter:

Kawasaki: Kawasaki P/N 49019-7005

Fuel Shut-Off Valve:

All Units: 1/4 turn increments (“ON”, “OFF”).

Electrical System

Charging System: Flywheel Alternator

Charging Capacity: 15 amps

Battery Type: BCI Group U1

Recommended Minimum Battery CCA: 260 CCA

Battery Voltage: 12 Volt

Polarity: Negative Ground

Fuses: All units:

25 amp main fuse

25 amp charging system fuse

10 amp PTO fuse

15 amp accessory fuse

Operator Controls

Steering and Motion Control:

Note: Motion control levers are adjustable to three heights.

Separate levers, on each side of the console, control speed and direction of travel of the respective drive wheels.

Steering is controlled by varying the position of the levers relative to each other.

Moving motion control levers outward (in slots) locks the drive system in neutral.

PTO Engagement Switch: Engages electric clutch (to drive belt) which engages mower blades.

Parking Brake Lever: Engages parking brake.

Deck Height Adjustment Lever: Sets cutting height to desired position.

Deck Lift Pedal: Foot pedal that lifts deck.

Transport Lock: Latching position: Automatically latches at the transport position.

Seat

Type: Standard seat with foam padded seat cushion with armrests and integral safety switch.

Optional seat: Seat with high back, extra wide foam padded seat cushion with internal suspension, thick bolstering, two-tone cover,

15

Page 15
Image 15
Exmark 920 Specifications, Model Numbers, Systems, Engine, Safety Interlock System, Fuel System, Electrical System, Seat