Exmark FMD524 manual Position Discharge Chute, Service Hydraulic OIL, Support PIN Location

FIGURE 1

SUPPORT PIN LOCATION

3.5.5Mower Deck Stationary Idler Installation:

Locate the two holes along the back center section of the deck and install the stationary idler and related parts (from bolt bag) in the right hand hole. See Figure 2. Be sure the coned end of the disc spring washer is against the head of the bolt. Tighten hardware.

3/8-16 x 4 1/2

HEX CAPSCREW

FIGURE 2

STATIONARY IDLER INSTALLATION

3.5.6Install the deck drive belt around the clutch. Refer to belt routing decal. Be sure belt is in the clutch drive sheave groove. Place the other end of the belt into the V-groove of the stationary idler, move the spring loaded idler outward and route the belt around the inside of the spring loaded idler. Position the belt into the V- groove of the mower deck drive sheave. Carefully release the spring loaded idler. Install the center belt shield.

3.5.7Adjust cutting height of deck and anti-scalp rollers. See Adjustment Section 5.2.1.

3.6POSITION DISCHARGE CHUTE:

Loosen two (2) 5/16” nyloc nuts attaching discharge chute. Lower the discharge chute into position. Retighten nyloc nuts until chute is snug but can pivot freely.

3.7SERVICE ENGINE: See Engine Operator's Manual.

3.8SERVICE HYDRAULIC OIL

The machine is shipped with hydraulic oil in the reservoir. Run the machine for approximately 15 minutes to allow any extra air to purge out of the hydraulic system. Check hydraulic reservoir and if necessary fill the reservoir to the appropriate level with Mobil 1 15W-50 synthetic motor oil. Replace hydraulic reservoir cap and tighten until snug. Do not overtighten.

- 14 -