Maintenance
between the spring retainer bracket and the adjacent nyloc nut. Tighten the jam nut above the trunnion roller.
4.If adjustment is necessary, loosen the nut directly below the yoke. Turn the bottom nut (below washer) until the correct measurement is obtained (see Figure 18) turn nut clockwise to lengthen the gap (screws rod into yoke) and turn counterclockwise to shorten the gap (screws rod out of yoke). Tighten nut against yoke and check opposite side of unit, repeat if necessary. Lengthen (or shorten) the brake rod until the correct gap can be achieved by following steps 2 and 3.
Electric Clutch Adjustment
No adjustment necessary.
Reverse Indicator
Adjustment
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Unhook seat latch and tilt seat forward.
3.Begin with either the left or right motion control lever. Move lever to the neutral position and pull lever back until the clevis pin (on arm below pivot shaft) contacts the end of the slot (just beginning to put pressure on spring). (Figure 19).
4.Check where lever is relative to notch in console (should be centered allowing lever to pivot outward to the neutral lock position).
5.If adjustment is needed, loosen the nut against the yoke and while applying slight rearward pressure on the motion control lever, turn the head of the adjustment bolt in the appropriate direction until lever is centered (keeping rearward pressure on the lever will keep the pin at the end of the slot and allow the adjustment bolt to move the lever to the appropriate position). Tighten lock nut.
6.Repeat on opposite side of unit.
Figure 19
1. | Turn bolt here | 4. | Yoke |
2. | Lever centered in notch | 5. | Loosen here |
3. | End of slot | 6. | Reverse indicator |
|
|
|
|
Motion Control Linkage Adjustment
WARNING
Engine must be running and drive wheels must be turning so motion control adjustment can be performed. Contact with moving parts or hot surfaces may cause personal injury
Keep fingers, hands, and clothing clear of rotating components and hot surfaces.
CAUTION
Raising the mower deck for service or maintenance relying solely on mechanical or hydraulic jacks could be dangerous. The mechanical or hydraulic jacks may not be enough support or may malfunction allowing the unit to fall, which could cause injury.
Do Not rely solely on mechanical or hydraulic jacks for support. Use adequate jack stands or equivalent support
36
