Exmark OCD01 manual Chute with LIP Removed

c) Remove remaining lip as shown in Figure 16C.

G0945

G0938

FIGURE 16C	FIGURE 16D
CHUTE WITH LIP	CHUTE WITH LIP REMOVED

d)Using the existing hardware, reinstall the discharge chute bracket into the flexible discharge chute as shown in Figure 17.

For UltraCut Only: Install 5/16-18 x 1-1/4 screw (item 20) and 3 or 4 washers (item 6) in the center hole of the bracket as shown in Figure 17, so that the edge of the chute will be parallel with the deck in the down position.

FIGURE 17

e)When installation is completed, rotate gate assembly (item 16) through its full travel range and check clearance with discharge chute. Trim additional material from discharge chute if necessary.

3.2.19Reinstall the belt cover.

13