Exmark Quest Bagger Installing the Hood and Bags, Parts needed for this step, Procedure, Figure

2.Install the two 3/8-16 x 5 carriage bolts (item 1) through the holes on the frame as shown in Figure 5. Place two stiffeners (item 2) on the top and bottom of the bagger tube (item 4) and install on carriage bolts. Fasten with two nyloc nuts (item 3); leave loose to aid installation. Repeat procedure for other side.

Figure 5

1.	Bolts	2.	Stiffener
3.	Nuts	4.	Bagger tube
5.	Screws	6.	Stiffener

7.Bagger hitch

3.Align the holes in the bagger tube (item 4) with the bagger hitch (item 7). Fasten with hardware and stiffener as shown in Figure 5; leave loose to aid in installation.

4.Tighten all hardware.

Installing the Hood and Bags

Parts needed for this step:

Description	Qty.
Screw, PPH 1/4-20 x 3/4	2
Asm, Bagger Mount	1
Nut, Nyloc 1/4-20 Flg	2
Asm, Hood Bagger	1
Bags	2

Procedure:

Operating the mower with the bagger installed and the front weight removed may cause loss of traction and steering control or an unstable condition which could result in injury or death.

Install the bagger only when the front weight is installed.

1.Install the bagger mount assembly (item 2) onto to the hood assembly (item 3) using two 1/4-20 x 3/4 screws (item 1) and nyloc nuts (item 4) as shown in Figure 6.

	Figure 6
1. Screws	2. Bagger mount assembly
3. Hood assembly	4. Nuts

5.Bagger hitch

2.Install the mount assembly onto the hitch.

9