UTS 100 Series • Setup Guide
The Extron UTS 100 and UTS 150
Included Parts
UTS 100 | UTS 150 |
| |||
(8) | (8) | ||||
(4) #8 x 1/2 inch shelf mounting screw | (2) |
| |||
Step 1 — Mount Devices on the Shelf | Hexagonal | ||||
|
|
|
| ||
|
|
|
| ||
ATTENTION: |
|
| Rack Mounting | ||
Some products have hexagonal holes | mounting circuit | ||||
board) |
| ||||
| in their base, which anchor stand‑offs for internal circuit |
| |||
|
|
| |||
| boards (see the figure to the right). Using these holes will |
|
| ||
| damage the product and will not provide secure mounting. |
| |||
Before securing a device to the shelf, decide where the device |
| ||||
will be placed. Ensure that adequate space remains for running | Wire tie | ||||
cables. |
|
|
| openings | |
1. | Place the device on the shelf so that the rack mounting |
| Product | ||
UTS 100 | mounting | ||||
| holes are aligned with two diagonally opposite product |
| holes | ||
|
|
| |||
| mounting holes in the shelf (see figure at right). |
|
| ||
| Remove any rubber feet attached to the device. |
|
|
2. Secure the device to the shelf, using two of the provided
3. Use the rectangular (wire tie) openings for tie wraps if necessary.
(2)
Use 2 mounting holes on diagonally opposite corners of device.
Step 2 — Install the UTS 100 (Primary Shelf) Under the Table
The UTS 100 may be mounted under furniture in one of two ways: using the keyhole slots for
a removable installation or the clearance holes for a fixed installation.
1. Hold the UTS 100 under the desk or table and mark the locations of four corner mounting holes.
Keyhole slot
Clearance hole