HAE 100 • Setup Guide
The Extron HAE 100 HDMI® Audio
This guide provides basic instructions for an experienced installer to set up and operate the HAE 100.
CAUTION: Installation and service must be performed by authorized personnel only.
Installation
Step 1 — Turn Off the HAE 100 and All Devices
Turn the input and output devices off and unplug their power cords. Verify that the HAE 100 is disconnected from the power source before proceeding.
Step 2 — Connect HDMI Input Device
Connect an input device to the HDMI input connector (B).
Step 3 — Connect HDMI Output Device
If necessary, connect an output device to the HDMI output connector (C).
NOTE: It is not required to connect an HDMI output device to extract audio from the HDMI input device.
Step 4 — Connect Audio Output Devices
The HAE 100 extracts audio using the following connectors. Connect audio output devices to at least one of the following connectors.
zz S/PDIF output (D) — This connector extracts digital S/PDIF audio. Connect an audio output device to this connector using an
RCA cable.
1 | 2 | 4 | 5 |
|
|
| HAE 100 | |
INPUT |
|
|
|
|
HDMI | AUDIO |
| HDMI OUTPUT AUDIO | |
| FORMAT |
| EDID |
|
POWER |
|
|
| |
S/PDIF | ANALOG | STORE | ON | |
12V | L | R | ON | |
0.4A MAX |
|
|
|
|
HDMI |
|
|
|
|
|
|
| 1 | 2 |
| OUTPUTS |
|
| OFF |
|
|
|
|
3
Figure 1. HAE 100 Rear Panel
|
| CAUTION |
|
| For unbalanced audio, connect the |
Do not tin the wires! | sleeve(s) to the ground contact. | |
DO NOT connect the sleeve(s) to the | ||
|
| negative |
Tip | L | Tip | L | |
Ring | NO GROUND | |||
|
| |||
Sleeve(s) |
| Sleeve(s) |
| |
Tip | R | Tip | R | |
Ring | NO GROUND | |||
|
|
Balanced Output | Unbalanced Output |
Figure 2. Analog Output Connector Wiring
zz Analog output (E) — This connector extracts
Step 5 — Power On the HAE 100 and All Devices
Wire the power supply (see figure 3) and connect it to the power connector (A). When power is applied to the unit, the front panel LED lights.
Connect the power cords of the input and output devices and turn them on. The sound should be audible. If an output display is connected to the HDMI output (C), the picture should appear.
Smooth | Ridges |
| |
A | A |
SECTION
Power Supply | Tie Wrap |
Output Cord |
|
3 5
Captive Screw
Connector
Figure 3. Power Supply Wiring
Front Panel Overview
LEDs
These LEDs indicate the status of the input and output signal that is being sent through the HAE 100 and the devices that are connected to it.
Input LEDs
zz Signal — This LED lights when the unit is receiving a signal from the HDMI input.
zz HDCP — This LED lights when the HDMI input signal is encrypted with
zz
INPUT
SIGNAL
HDCP
BITSTREAM
zz Bitstream — This LED lights when the embedded audio signal is a Dolby Digital® or
DTS® format.
1