CInput connector — This 3.5 mm,
ATTENTION: The length of the exposed wires in the stripping process is critical. The ideal length is 3/16 inches (5 mm). Any longer and the exposed wires may touch, causing a short circuit between them. Any shorter and the wires can be easily pulled out even if tightly fastened by the captive screws.
NOTE: Do not tin the wires. Tinned wires are not as secure in the connector and |
could be pulled out. |
Tip | 1 |
Ring |
|
Sleeves |
|
Tip | 2 |
Ring |
Balanced Stereo Input
Do not tin the wires!
Tip | 1 |
| |
Sleeve |
|
Tip |
|
Sleeve | 2 |
1 Tip
Ring
Sleeve 2
Balanced Dual Mono Input
1
Tip
Sleeve
2
Unbalanced Stereo Input | Unbalanced Dual Mono Input |
Figure 4. Audio Input Connectors
DOutput connector — The 3.5 mm,
ATTENTION: For unbalanced audio output, connect sleeves to the center ground pin. DO NOT connect sleeves to the negative
NOTE: Do not tin the wires. Tinned wires are not as secure in the connector and |
could be pulled out. |
Tip |
Ring |
Sleeves |
Tip |
Ring |
No Ground Here
1 | Tip | 1 |
|
| |
| Sleeves |
|
2 | Tip | 2 |
No Ground Here
Do not tin the wires! | Balanced Audio Output | Unbalanced Audio Output |
Tip-ring-sleeve and tip-sleeve connections:
Tip (L)
Ring (R)
Sleeve ()
Tip (+)
Sleeve ()
Figure 5. Audio Output Connectors
BUC 202 User Guide • Setup and Operation | 4 |