Extron electronic 200, 300C, 300S, 600, 800, Cable Cubby 200, Cable Cubby 600, Cable Cubby 800

Cable Cubby® Products • Installation

Installation, cont’d

2-6 Cable Cubby® Products • Installation

2-7

Preparing the table with a hole saw

(Cable Cubby 300C only)

Prepare the table with a hole saw as follows:

1. On the tabletop or other installation surface, mark the 6"

circle, then ﬁ nd and mark the center of the circle.

W Wear safety glasses when operating the drill.

Failure to comply can result in eye injury.

2. Using a portable drill with a 6" (or 152 mm) hole saw,

carefully cut the opening in the table surface at the

desired location (ﬁ gure 2-3). Extron is not responsible for

improperly positioned Cable Cubbies.

C Use a portable drill with sufﬁ cient power to handle

the 6” hole saw. Exercise caution when handling

the drill and hole saw. Take care to protect the

mounting surface from damage.

Figure 2-3 — Cutting the opening with a hole saw

Installing the Cables and AAPs

Each Cable Cubby 300, 600, and 800 model ships with one or

two moveable AAP shelf assemblies. The Cable Cubby 200’s

AAP shelf is ﬁ xed in place.

AAP shelf brackets (CC 300, 600, 800)

Each shipped AAP shelf assembly consists of a set of shelf

brackets and a number of cable pass-through (split) AAPs.

Depending on the Cable Cubby model, each set of shelf

brackets supports either two, three, or four single-space AAPs

(ﬁ gure 2-4).

Four-Space Shelf Bracket

and Split AAPs

Three-Space Shelf Bracket

and Split AAPs

Two-Space Shelf Bracket

and Split AAPs

Figure 2-4 — Shelf brackets

The simplest way to install the cables and AAPs in the Cable

Cubby 300, 600, and 800 is to populate the shelf brackets with

split and/or standard AAPs outside the cubby and then install

the populated AAP shelf assembly into the cubby.

N Cable cubby 300, 600, and 800 only —

On US/domestic models, the power module takes up

two AAP spaces. On IEC, EU, Swiss, UK, Israeli, and

Australian models, the power module takes up three

AAP spaces. Cable pass-through AAPs take two, three,

or four AAP spaces. Consider the arrangement of the

Cable Cubby AAPs when you install them so that you do

not waste AAP space.