Extron electronic DVI-RGB 200 setup guide Operation, Front Panel Controls and Indicator

DVI-RGB 200 Setup Guide (Continued)

Operation

Apply power to the devices in the following order: 1) DVI-RGB 200, 2) display device, 3) input device. After all devices are powered up, the system is fully operational.

If any problems are encountered, verify that the cables are routed and connected properly. If your problems persist, call the Extron S3 Sales & Technical Support Hotline that is closest to you, at the number shown below.

NOTES: • High-bandwidth Digital Content Protection (HDCP) is an encryption method that protects copyrighted digital

entertainment material that uses DVI video.

• The DVI-RGB 200 cannot respond to the HDCP decryption key. When the DVI input is HDCP encrypted, the

output of the DVI-RGB 200 RGB is blank.

• The computer reads the DDC on power up to determine the direct digital video resolution and refresh rate

to output. Ensure that the local DVI monitor and the RGBHV monitor can both display the selected resolution

and refresh rate, otherwise images may be distorted or missing.

• Ensure that the computer and local monitor are connected to the DVI-RGB 200, and the DVI-RGB 200 and local monitor have power applied, before applying power to the computer. If the other devices are not turned on before the computer is powered on, the image will not appear.

Front Panel Controls and Indicator	8	9	10
NOTE: Level Boost and Peaking have no affect on the DVI		LEVEL	PEAK
output of the Buffered Loop-through connector.
		BOOST	CONTROL	DVI-RGB 200
h Power LED — The two-color Power LED lights amber or				DVI TO RGB CONVERTER

green:

Amber when the DVI-RGB 200 is receiving power but no DVI input signal is applied. Green when the DVI-RGB 200 is receiving power and a DVI input is present.

iLevel Boost control — The Level Boost control alters the brightness of the picture on the RGB output. Judge the adjustment visually by looking at the display.

•At the minimum level setting (the counterclockwise limit of this control), the interface outputs video at 0.7 Vp-p.

•At the maximum level setting (the clockwise limit of this control), the interface outputs video at 1.45 Vp-p.

Select a level setting of 0.7 V and above to compensate for the signal level decrease that occurs with long cables. Set the level at the maximum setting for cable lengths over 500 feet.

j	Peak(ing) control — The Peaking control affects the sharpness of the RGB output. Increased peaking can compensate
	for detail (mid- and high-frequency) loss from low bandwidth or long cables. The minimum setting (counterclockwise
	limit) provides no peaking. The maximum setting (clockwise limit) provides 100 percent peaking.			SOGON/OFFHIGHREFRESH
Capturing a User-recorded EDID			DDC		EDID
					SELECT
Record the EDID from a display connected on the Buffered Loop-through connector as follows:			SOURCE
			MONITOR
	1.	Set the rear panel EDID Source switch to the Selector (down) position.
	2.	Set the Output Resolution switch to the 0 position.
			SELECTOR
				LOW
	3.
		Change the Refresh dip switch to on (up).

NOTE: The front panel Power LED lights amber whether the DVI-D Input connector is receiving a signal or not.

4.Connect the unpowered display device to Buffered Loop-through connector.

5.Power on the display device. The DVI-RGB 200 copies the EDID of the display connected in step 4 to its memory. After the EDID is successfully copied, the front panel Power LED lights green.

6.Set the Refresh DIP switch to off (down).

Extron USA - West	Extron USA - East	Extron Europe	Extron Asia	Extron Japan	Extron China	Extron Middle East
Headquarters
+800.633.9876	+800.633.9876	+800.3987.6673	+800.7339.8766	+81.3.3511.7655	+400.833.1568	+971.4.2991800
Inside USA/Canada Only	Inside USA/Canada Only	Inside Europe Only	Inside Asia Only	+81.3.3511.7656 FAX	Inside China Only	+971.4.2991880 FAX
+1.714.491.1500	+1.919.863.1794	+31.33.453.4040	+65.6383.4400		+86.21.3760.1568
+1.714.491.1517 FAX	+1.919.863.1797 FAX	+31.33.453.4050 FAX	+65.6383.4664 FAX		+86.21.3760.1566 FAX

© 2010 Extron Electronics. All rights reserved. www.extron.com

68-1791-50 Rev A

1010

2