HDMI DA2 • Setup Guide
Overview
The Extron HDMI DA2 distribution amplifier distributes one HDMI input signal to two outputs simultaneously. This setup guide provides instructions for a basic installation by an experienced installer. For complete instructions, see the HDMI DA2 User Guide, which is available on the Extron web site (www.extron.com).
Front Panel
c
| INPUT | OUTPUTS |
| |
| 1 | 2 | EDID | |
CONFIG | SIGNAL |
|
| |
|
|
| ||
|
|
|
|
HDCP
HDMI DA2
a b d e
APower status LED — Lights green when power is applied to the unit.
BUSB Config port — Used for SIS configuration, monitoring, and firmware updates.
CSignal LEDs — Light green when a TMDS signal is detected on the HDMI input and is being transmitted on the appropriate output.
DHDCP LEDs — Light green when a HDCP has been authenticated on the HDMI input and the appropriate output (if required).
EEDID LED — Lights green when the EDID is successfully stored from the selected output device (output 1 by default). Lights amber if
Rear Panel
POWER |
|
|
| REMOTE | ||
12V |
| 1 | 2 | |||
0.4A MAX |
| |||||
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| INPUT |
| OUTPUTS | TxRx G |
| a | b | c |
| d |
APower input — Connect the provided 12 VDC, 1 A power supply to this power input.
BHDMI input — Connect a source device into this female HDMI type A connector.
CHDMI outputs — Connect display devices into these female HDMI type A connectors.
D
Installation
1.Mount the HDMI DA2 in a suitable location (see the “Mounting” section of the HDMI DA2 User Guide for mounting options). Follow the instructions provided with the mounting kit.