Software-based Configuration and Control, cont’d
IPL 250 • Software-based Conguration and Control
3-6
4. Select the Configuration tab, then select System Settings from the menu on
the left of the screen. A Web page appears. The top part of a typical screen is
shown in the following picture.
5. Set the IPL for the new IP address using either step 5a or step 5b.
5a. Enter the new IP address for the IPL 250, the corresponding subnet
mask, and the gateway address. IP addresses and subnet masks
follow standard naming and numbering conventions. The IP network
administrator should provide the IP addresses and subnet mask to be
used with this controller.
5b. Select DHCP On.
6. Click Submit. It takes a minute or more for the controller to store the new
settings. Once the controller’s IP address is changed, you lose communication
with the controller.
7. Close the browser.
8. After changing the controller’s IP settings, change your PC’s TCP/IP settings
back to their original configuration.
Configuring the IPL for network use via SIS™ commands and
Telnet
The IPL and the PC must both be part of the same subnet before they can
communicate via the LAN port. You must change the PC’s IP address to one that is
on the same subnet as the default IP address of the IPL 250 (192.168.254.254).
N This method requires connecting the IPL to the PC’s LAN port using a crossover
network cable. See page 2-6 for cabling details.
N Make a note of the host PC's TCP/IP configuration before changing its IP
address and make sure the PC and IPL are on the same subnet.
1. Temporarily change the host PC’s IP address. See “Setting up the PC for
IP communication with an IPL 250” on the next page for step-by-step
instructions.
2. Start Telnet on the PC
a. Click the Start menu and select Run. The Run dialog box appears.
b. Type telnet, a space, and the default IP address (192.168.254.254) into
the Open area, and click OK.