Software-based Configuration and Control, cont’d
IPL 250 • Software-based Conguration and Control
3-8
2. Right-click on Local Area Connection, then select Properties.
3. Select Internet Protocol (TCP/IP)
and click on the Properties button
(shown at right). If Internet Protocol
(TCP/IP) is not on the list, it must be
added (installed). Refer to the
Microsoft Windows user’s manual or
the Windows online help system for
information on how to install the
TCP/IP protocol.
4. Write down the PC’s current IP
address and subnet mask below.
If your PC is set to “Obtain an IP
address automatically,” make a note
of that, instead. You will need to
restore these settings to the PC later.
IP address:
. . . .
Subnet mask:
. . . .
5. Change the PC’s IP address so it can communicate with the IPL 250 and
change the controller’s IP settings.
a. Click the Use the following IP address button.
b. Enter the following values, as shown in the following picture:
IP address: 192.168.254.253
Subnet mask: 255.255.0.0
Default gateway: blank or 0.0.0.0