Extron electronic IPL T PC1 specifications AC control interface, Serial control interface

Specifications — IPL T PC1, IPL T PC1i

AC control interface

Connectors
IPL T PC1	1 female USA/Edison power connector
IPL T PC1i	1 female IEC power connector
Voltage
IPL T PC1	120 VAC, 50-60 Hz
IPL T PC1i	220 VAC, 50-60 Hz
Maximum AC load
IPL T PC1	12 A, 1440 watts at 120 VAC
IPL T PC1i	10 A, 2200 watts at 220 VAC

Serial control interface

Serial control port	(1) RS-232 only, 3.5 mm captive screw connectors, 4 pole
Baud rate and protocol	115200 to 300 baud (9600 baud = default) ; 8 (default) or 7 data bits; 1 (default) or 2
	stop bits; no parity (default), or even or odd parity
Serial control pin configurations	1 = TX, 2 = RX, 3 = GND, 4 = +5 VDC

Ethernet control interface

Connector	1 RJ-45 female connector
Data rate	10/100Base-T, half/full duplex with autodetect
Protocols	ARP, DHCP, ICMP (ping), TCP/IP, UDP/IP, Telnet, HTTP, SMTP
Default settings	Link speed and duplex level = autodetected
	IP address = 192.168.254.254
	Subnet mask = 255.255.0.0
	Gateway = 0.0.0.0
	DHCP = off
Web server	Up to 200 simultaneous sessions
	7.25 MB nonvolatile user memory
Program control	Extron’s Simple Instruction Set (SIS™)
Global Viewer requirements	Microsoft® Internet Explorer ver. 6 or higher

Contact closure interface (input only)

Quantity/type	1 contact closure input
Contact input control connector . (1) 3.5 mm captive screw connector, 4 pole (shared with IR output port)
Contact closure (input only)
Input voltage range	0 to 5 VDC, clamped at +5.1 V
Input impedance	10k ohms
Threshold	1.6 VDC
Pin configuration	1 = contact input, 2 = GND

IR control interface

IR control port	(1) 3.5 mm captive screw connector, 4 pole (shared with contact closure input port)
Pin configurations	3 = S (IR signal output), 4 = GND
IR output carrier frequency	30 kHz to 1 MHz

General

Power input	100 VAC to 240 VAC, 50/60 Hz, 5 watts, internal, on 1 male IEC power connector
IPL T PC1	12 A (max.)
IPL T PC1i	10 A (max.)
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
	Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling	Convection, unvented

1-2IPL T PC1, IPL T PC1i Power Control • Specifications