Setup and Operation, cont’d
The following figure shows the buttons that become available when VCR mode is selected:
POWER
ONTV/VCR
CHANNEL
FRONT PANEL
VOL
PC
VOL
VIDEO
DVD
DVD
VCR
Press this button first.
VCR
Controlling the MLC 104
The IR 452 can control an MLC 104 through a DVCM 50 that is connected to the MLC rear panel host port.
Refer to the DVCM 50 User's Manual for wiring instructions.
IR 452 to MLC 104 communication process
The following occurs when you press a button on the IR 452:
1. | An IR signal goes from the button to the IR Link or IRL 20, | ||
| then to the DVCM. |
|
|
2. | The DVCM interprets the IR signal and responds to it by | ||
| sending the appropriate SIS command to the MLC 104. | ||
| You do not need to program any buttons on the | ||
| DVCM 50 for it to interpret the signals it receives from | ||
| the IR 452. |
|
|
| VCR | VCR DVD |
|
| SYSTEM | DVD | FRONT PANEL |
| REMTEO 452IR |
|
|
SIGNAL
SIGNAL
IR 452
IR LINK
IR LINK
IR Link
IR 452
SYSTEM REMOTE
VCR control buttons on the IR 452
PROJECTOR | |
ON | OFF |
VOLUME
VIDEO
AUX
VIDEO
PC
CONFIG IMAGE
MUTE
1
2
3
4
SIS commands from DVCM 50
CONFIG |
MLC 104
DVCM 50
Remote control of the MLC 104
3. The MLC 104 activates the button on its front panel that is associated with the SIS command it receives. When the button is activated, the command programmed to it is sent to the projector or display device.
IR 452 • Setup and Operation |
