![Quick Start Guide — IRL 20, cont’d](/images/new-backgrounds/15597/155977x1.webp)
Quick Start Guide — IRL 20, cont’d
communications connector. If desired, terminate the other end of the cable and plug it into a communications connector on an optional control module.
Step 7
Verify correct wiring and cabling, and test the system: connect the devices to a power source, turn them on, aim an IR remote control at the IRL 20, and check for the appropriate response at the remotely controlled Extron device.
Step 8
If needed, disconnect all the devices from the power source(s), and correct any cabling errors.
Step 9
Restore power to the equipment.
Table of Contents
Chapter 1 • Introduction | |
About the IRL 20 | |
Features | |
Chapter 2 • Installation and Operation | |
UL Requirements | |
Front and Rear Panel Features | |
Connecting an IRL 20 to a MediaLink switcher or |
|
controller, an AVT 100, or another Extron product | |
Connecting an IRL 20 to a power supply |
|
and an IR Emitter | |
Appendix A • Specifications, Part Numbers, |
|
and Accessories | |
Specifications |
Extron System 5 IP
Extron
IRL 20
V | ND | CM | IRod | PCS | V | ND | CM | RodI | PCS |
12+ | G | M | 12+ | G | M |
IR SNSR
IRL 20
+ | _ | + |
R
_
Extron IR Sensor
Included Parts | |
Accessories | |
Cables |
All trademarks mentioned in this manual are the properties of their respective owners.
Equipment Room
Extron
IR 402 Remote
Meeting Room
|
|
| Extron |
PROJECTOR |
|
| IRL 20 |
ON OFF LIGHT |
| AUX | |
ON | VCR DVD | VIDEO |
VOLUME | LIGHT |
|
|
| OFF |
|
|
| AUTO | PC | PC |
| IMAGE |
|
|
MLC 226 IP
Extron
MLC 226
Equipment Room
Extron
IR 402 Remote
Meeting Room
12 04
IRL 20 • Table of Contents | i |