MTP 1500RL 15HD A SEQ • Setup Guide
This guide provides basic instructions for an experienced installer to set up and operate the Extron MTP 1500RL 15HD A SEQ twisted pair receiver.
For full details, see the MTP 1500RL 15HD A SEQ User Guide, available online at www.extron.com.
RED | LEVEL | PEAKING |
SELECT GREEN
BLUE | ADJUST |
| MIN/MAX |
DELAY | RGB | MTP 1500RL Series |
INPUT | BUFFERED OUTPUT | OUTPUT |
|
POWER |
| MONO | AUDIO |
12V |
| L | R |
1.0A MAX |
|
|
|
MTP | MTP |
|
|
SPARE
END
VIDEO
SOG
CSYNC
V +
H +
ON |
MTP 1500RL 15HD A SEQ |
Installation and Setup
Step 1 — Mounting
Turn off or disconnect all equipment power sources. Mount the MTP 1500RL 15HD A SEQ receiver as required.
Step 2 — Connect Input
Connect the
Terminate the cable as shown below right, using the same standard (A or B) at both ends.
|
|
|
|
|
| Pin | T568A Wire | T568B Wire |
|
|
|
|
|
|
| Color | Color |
|
|
| ||||||
|
|
| ||||||
1 | ||||||||
|
| Pins: |
|
|
| |||
12345678 |
|
| 2 | Green | Orange | |||
|
|
|
|
|
| |||
|
|
|
|
|
| 3 | ||
|
|
|
|
|
| |||
|
|
|
|
|
| |||
|
|
|
|
|
| 4 | Blue | Blue |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 5 | ||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 6 | Orange | Green |
|
|
|
| |||||
Insert Twisted | 7 | |||||||
| Pair Wires |
|
|
| ||||
| 8 | Brown | Brown | |||||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
NOTE: The transmitter and receiver are designed for and perform best with Extron Enhanced
Step 3 — Connect Outputs
Attach the applicable output cables (video, audio, and buffered output).
A.High resolution video output — Connect a display device to the
B.Audio connector — Connect an audio device to the
| Mono output 1 | MONO 1 | Mono output 1+ |
| NO GROUND. | Mono output 1- | |
| Sleeve(s) | AUDIO 2 | Sleeve(s) |
Do not tin the wires! | Mono output 2 | Mono output 2+ | |
NO GROUND. |
| Mono output 2- |
Unbalanced Output | Balanced Output |
CAUTION
For unbalanced audio, connect the sleeve(s) to the ground contact.
DO NOT connect the sleeves to the negative
MONO AUDIO 1 2
C.Buffered output — Connect up to 5