Extron electronic MTP 15HD manual Transmitter Rear Panel Features, 15-pinHD Connector NOTES

Transmitter Rear Panel Features

Figure 3 shows the rear of an MTP T 15HD RS transmitter.

4

	RS-232
POWER	Tx Rx G

MTP T 15HD RS

PRE-PEAK

12V	ON
0.5A MAX

	INPUT	MONITOR	OFF	OUTPUT
1	2	3	5	6

Figure 3. Transmitter Rear Panel

NOTE: Control signal ground pins may be labeled as or “G”. Audio ground pins may be labeled as or .

The wiring and function are the same, whichever way your product is labeled.

APower connector — Plug the included external 12 VDC power supply into this

2-pole captive screw connector (see Power Supply Wiring on page 12 to wire the connector).

BInput video connector — Connect a computer video source to this 15-pin HD connector for high resolution video input (see figure 4).

10 5 1 6

15 11

Female

Figure 4. 15-pin HD Connector

NOTES:

•Input only sync signals (no video signals) on the sync pins (13 and 14).

•For component video, use the R (R-Y) and R return pins (pins 1 and 6), G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return pins (pins 3 and 8). For S-video, use the R, R return (C-chroma), G, and

G return (Y-luma) pins.

•For composite video, use the G pin and the associated return pin. For additional genlocked video signals, use the R, B, and associated return pins.

CMonitor connector — Connect a video monitor to this 15-pin HD connector for buffered, high resolution video loop-through.

DRS-232 connector — Connect a serial communications port to this 3.5 mm, 3-pole captive screw connector for bidirectional RS-232 communication.

Wire the connector as shown in figure 5.

Connected RS-232

Device Pins

Receive

Transmit

Ground

MTP

Pins

Tx

Rx

G

Figure 5. RS-232 Connector Wiring

MTP 15HD RS Series • Installation and Operation 9