Extron electronic MTP 15HD Receiver Rear Panel Features, ATTENTION Potential damage to property

Receiver Rear Panel Features

Figure 6 shows an MTP RL 15HD RS receiver.

MTP RL 15HD RS

BUFFEREDOUTPUTS POWER INPUT OUTPUT

12V

0.5A MAX

OUTPUT

RS-232

3

Tx Rx G

1	2	3	4
Figure 6.	Receiver Rear Panel

NOTE: Control signal ground pins may be labeled as or “G”. Audio ground pins may be labeled as or .

The wiring and function are the same, whichever way your product is labeled.

APower connector — Plug the included external 12 VDC power supply into this 2-pole captive screw connector (see Power Supply Wiring and Grounding on the following page to wire the connector).

ATTENTION: Potential damage to property.

Before wiring the connector, read the notes, attentions, and warnings in the Power Supply Wiring and Grounding section on the following page.

BInput connector — Connect one end of the TP cable from the transmitter or from the buffered output connector of an RL receiver to this RJ-45 female connector.

CBuffered output connector — Connect one end of a TP cable to this female RJ-45 connector. Connect the opposite end of the same TP cable from the receiver to the Input RJ-45 female connector on another receiver (see Twisted Pair Cable Termination on page 14 to wire the RJ-45 connectors).

ATTENTION: Potential damage to property.

Do not connect these devices to a computer data or telecommunications network.

DOutput video connector — Connect a projector or other high resolution video device to this 15-pin HD connector.

ERS-232 connector — Connect a serial communications port to this 3.5 mm, 3-pole captive screw connector for bidirectional RS-232 communication. Wire the connector as shown in figure 5 on page 9.

MTP 15HD RS Series • Installation and Operation 11