Extron electronic MTP 15HD manual Front Panel Features, MTP Front Panels

Front Panel Features

See figure 2 below to identify the front panel features on the transmitter and receiver.

MTP T 15HD RS Transmitter

50 Hz		EDID
		SELECT
	ON

1 RECORD

			60 Hz		SPARE MTP SERIES
		2	3	4	5
	MTP RL 15HD RS Receiver
						RGB
					LEVEL	PEAKING
1
					MTP SERIES
					6	7
	MTP RL 15HD RS SEQ Receiver
		DELAY
						RGB
		RED			LEVEL	PEAKING
1	SELECT	GREEN
		BLUE
					MTP SERIES
	8	9	10		6	7

Figure 2. MTP Front Panels

NOTE: Control signal ground pins may be labeled as or “G”. Audio ground pins may be labeled as or .

The wiring and function are the same, whichever way your product is labeled.

APower LED — The LED indicator lights when the unit is receiving power.

BRecord LED — The LED indicator flashes red during the EDID recording process to indicate a new EDID being written to memory. The LED returns to a solid green after the

write completes.

CRecord button — The recessed record button is used to initiate recording of the EDID of a display device (connected to the loop-out) to user-programmable memory position

0 on the rotary switch (E).

DVertical frequency DIP switch — The first DIP switch selects the vertical frequency for the pre-programmed EDID. When switched to OFF (default position), the EDID selected by the rotary positions 1 through E are based on 60 Hz. When switched to ON, they are based on 50 Hz. The second DIP switch, marked SPARE, is not used.

NOTE: When the EDID select rotary switch (E) is in position 0 or F, the setting of the first DIP switch is not applicable because the user-recorded or attached display EDID is being used.

MTP 15HD RS Series • Installation and Operation 6